Search results
Results from the WOW.Com Content Network
The most important method to counter radar jammers is operator training. Any system can be fooled with a jamming signal but a properly trained operator pays attention to the raw video signal and can detect abnormal patterns on the radar screen. The best indicator of jamming effectiveness to the jammer is countermeasures taken by the operator.
When jamming is strong enough, the radar receiver can detect it from a relatively low gain sidelobe. The radar, however, will process signals as if they were received in the main lobe. Therefore, jamming can be seen in directions other than where the jammer is located. To combat this, an omnidirectional antenna is used for a comparison signal ...
Interference techniques include jamming and deception. Jamming is accomplished by a friendly platform transmitting signals on the radar frequency to produce a noise level sufficient to hide echos. [1] The jammer's continuous transmissions will provide a clear direction to the enemy radar, but no range information. [1]
Duke V3 Counter Radio-controlled Electronic Warfare jamming system Duke Version 3 Vehicle mounted CREW system : Duke V3, [ 4 ] manufactured by SRCTec, Inc., is a counter radio-controlled improvised explosive device (RCIED) electronic warfare (CREW) system that was developed to provide U.S. forces critical, life-saving protection against a wide ...
Other radar-confusing techniques included airborne jamming devices codenamed Mandrel, Piperack, Jostle and Carpet. Mandrel was an airborne jammer targeted at the German Freya radars, [10] while Carpet targeted the gun-laying Würzburg radar. Ignorance about the extent of knowledge of the principle in the opposing air force led planners to judge ...
ICE was developed by the Army Research Laboratory (ARL) at White Sands Missile Range and the Physical Science Laboratory (PSL) at New Mexico State University in 2004 to counter the rising IED threat in Iraq. Due to the urgent demand for counter-IED equipment, ICE was designed and built within three weeks and was provided to troops in less than ...
A laser jammer or lidar jammer is an electronic device used by drivers to prevent users of a LIDAR (or laser) gun from obtaining speed readings of their vehicle. Laser jammers are not to be confused with radar jammers. To jam LIDAR, laser jammers first must detect the emitted light, normally infrared light on the 904 nm wavelength. [12]
Since a DRFM system is designed to create a false target to a radar system, this technology can be employed to perform hardware-in-the-loop simulation. [1] [2] Hardware-in-the-loop simulation is an aid to the development of new radar systems, which allows for testing and evaluation of the radar system earlier in the design cycle. This type of ...