enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Light switch - Wikipedia

   en.wikipedia.org/wiki/Light_switch

   Shown here will be fastened to this recessed, non-metallic box, then a cover plate is installed. This "double gang" (two unit) installation uses non-metallic-sheathed cable and twist-on wire connectors. In electrical wiring, a light switch is a switch most commonly used to operate electric lights, permanently connected equipment, or electrical ...

3. Multiway switching - Wikipedia

   en.wikipedia.org/wiki/Multiway_switching

   The switches are then connected to each other by a pair of wires called "travelers" (or "strappers" in the UK), and the lamp is connected to the common terminal of the second switch, as shown. Using the traveler system, there are four possible permutations of switch positions: two with the light on and two with the light off.

4. Switch - Wikipedia

   en.wikipedia.org/wiki/Switch

   Two-way: A simple on-off switch: The two terminals are either connected together or disconnected from each other. An example is a light switch. SPST-NO. Form A [4] Single pole, single throw, normally open A simple on-off switch. The two terminals are normally disconnected (open) and are closed when the switch is activated. An example is a ...

5. Pull switch - Wikipedia

   en.wikipedia.org/wiki/Pull_switch

   The most common use of a pull switch is to operate a ceiling electric light.The ceiling fan and mechanical wall fans are also appliances often operated by pull switches. . Pull switches may be either two-position (open or closed) or multi-position (allowing for different fan speeds or levels of illuminati

6. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

7. Lighting control console - Wikipedia

   en.wikipedia.org/wiki/Lighting_control_console

   Generally, at least with a preset board, the operator has a cue sheet for each scene, which is a diagram of the board with the faders in their positions, as determined by the lighting designer. The operator sets the faders into their positions based on the cue sheets. Typically during a cue, the operator sets the next scene.