Search results
Results from the WOW.Com Content Network
The standard specifies a maximum open-circuit voltage of 25 volts: signal levels of ±5 V, ±10 V, ±12 V, and ±15 V are all commonly seen depending on the voltages available to the line driver circuit. Many RS-232 driver chips have inbuilt charge pump circuitry to produce the required voltages from a 3 or 5 volt supply. RS-232 drivers and ...
After the RS-232 COM port was removed from most consumer-grade computers, an external USB-to-UART serial adapter cable was used to compensate for the loss. A major supplier of these chips is FTDI . [ citation needed ]
Third-party applications can add this ability, such as the open-source com0com, freeware HW VSP3, or the commercial Virtual Serial Port Driver. Some virtual serial ports emulate all hardware serial port functionality, including all signal pin states, and permit a large number of virtual ports in any desired configuration.
FTDI US232R : USB to RS-232 cable. A USB-to-serial adapter or simply USB adapter is a type of protocol converter that is used for converting USB data signals to and from serial communications standards (serial ports). Most commonly the USB data signals are converted to either RS-232, RS-485, RS-422, or TTL-level UART serial data.
Data Terminal Ready (DTR) is a control signal in RS-232 serial communications, transmitted from data terminal equipment (DTE), such as a computer, to data communications equipment (DCE), for example a modem, to indicate that the terminal is ready for communications and the modem may initiate a communications channel.
The electric signaling levels are handled by a driver circuit external to the UART. Common signal levels are RS-232, RS-485, and raw TTL [1] for short debugging links. Early teletypewriters used current loops. It was one of the earliest computer communication devices, used to attach teletypewriters for an operator console.
A null modem adapter. Null modem is a communication method to directly connect two DTEs (computer, terminal, printer, etc.) using an RS-232 serial cable.The name stems from the historical use of RS-232 cables to connect two teleprinter devices or two modems in order to communicate with one another; null modem communication refers to using a crossed-over RS-232 cable to connect the teleprinters ...
This connector has been standardized for RS-232 as TIA-574. Some miniaturized electronics, particularly graphing calculators [5] and hand-held amateur and two-way radio equipment, [6] have serial ports using a phone connector, usually the smaller 2.5 or 3.5 mm connectors and the most basic 3-wire interface—transmit, receive and ground.