Search results
Results from the WOW.Com Content Network
Parallel communication; Parity bit; Payload (computing) Percept (information technology) Petherick code; Phase-fired controller; Phase-shift keying; Piggybacking (data transmission) Polar modulation; Primary station; Protocol data unit; Public data transmission service; Public switched data network
In telecommunication and data transmission, serial communication is the process of sending data one bit at a time, sequentially, over a communication channel or computer bus. This is in contrast to parallel communication , where several bits are sent as a whole, on a link with several parallel channels.
Practically all parallel communications protocols use synchronous transmission. For example, in a computer, address information is transmitted synchronously—the address bits over the address bus, and the read or write strobes of the control bus. Single-wire synchronous signalling
The basic difference between a parallel and a serial communication channel is the number of electrical conductors used at the physical layer to convey bits. Parallel communication implies more than one such conductor. For example, an 8-bit parallel channel will convey eight bits (or a byte) simultaneously, whereas a serial channel would convey ...
In telecommunications, transmission (sometimes abbreviated as "TX") is the process of sending or propagating an analog or digital signal via a medium that is wired, wireless, or fiber-optic. [ 1 ] [ 2 ]
At the destination, a second UART re-assembles the bits into complete bytes. Each UART contains a shift register, which is the fundamental method of conversion between serial and parallel forms. Serial transmission of digital information (bits) through a single wire or other medium is less costly than parallel transmission through multiple wires.
Asynchronous serial communication is a form of serial communication in which the communicating endpoints' interfaces are not continuously synchronized by a common clock signal. Instead of a common synchronization signal, the data stream contains synchronization information in form of start and stop signals, before and after each unit of ...
USARTs in synchronous mode transmits data in frames. In synchronous operation, characters must be provided on time until a frame is complete; if the controlling processor does not do so, this is an "underrun error," and transmission of the frame is aborted. USARTs operating as synchronous devices used either character-oriented or bit-oriented mode.