enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Jim Kelley Amplifiers - Wikipedia

   en.wikipedia.org/wiki/Jim_Kelley_Amplifiers

   Approximately 600 of these amps were built during that time. [2] The single-channel version of the amplifier employed modest gain in the preamp stages, Baxandall type bass and treble controls, a split load phase inverter, and four 6V6GT output tubes. [3] [4] The amplifiers produce 60 watts RMS at full power, and include a half power (30/60) switch.

3. Randall Amplifiers - Wikipedia

   en.wikipedia.org/wiki/Randall_Amplifiers

   In the early 2000s, the company worked with Bruce Egnater of Egnater Amplification to create the MTS (Modular Tube System) series of guitar amplifiers. These involve a single amp head consisting of the power amp and part of a preamp, and slots in the head (one for the RM20 head and combo, two for the RM50 head and combo and RM22 head, and 3 for the RM100 head and RM100C combo, and 12 for the ...

4. Peavey 5150 - Wikipedia

   en.wikipedia.org/wiki/Peavey_5150

   The 2×12 combo features 60 watts of RMS output power into 16 or 8ohms. It also features five 12AX7 preamps tubes and two 6L6GC power amp tubes. This combo also comes with a built in spring reverb unit that the head model does not have, controllable via the footswitch and indicated by a green LED when active. (Pg 3, button #9 in the manual) [13]

5. Fender Hot Rod Deluxe - Wikipedia

   en.wikipedia.org/wiki/Fender_Hot_Rod_Deluxe

   The Hot Rod Deluxe is an all tube combo amp rated at 40 watts. It utilizes a single 12-inch Celestion A-Type Speaker. It utilizes a single 12-inch Celestion A-Type Speaker. The Hot Rod Deluxe is a mono-channel amplifier featuring 3 switchable gain levels: "Clean", "Drive", and "More Drive" selectable on either the control panel or footswitch ...

6. THD Electronics - Wikipedia

   en.wikipedia.org/wiki/THD_Electronics

   All THD amplifiers utilize vacuum tubes for their preamp and power amp sections. Until the release of the Flexi-50 amplifier, they were all class A (the Flexi-50 is class AB ). This is why early THD UniValve prototypes were sometimes referred to as the “Pure Class A Head.” [ 6 ]

7. Peavey Electronics - Wikipedia

   en.wikipedia.org/wiki/Peavey_Electronics

   Vintage Series changed to a solid state pre-amp & a Master Volume (which is the easy way to tell if the amp has 6C10 pre-amp or not without removing the back panel to access the chassis), the solid state preamps and 6L6GC power tubes.