Search results
Results from the WOW.Com Content Network
However in an induction motor the fields from the rotor decrease as speed increases. A permanent magnet motor generates its own constant field. This means that as speed increases a voltage is induced linearly with the speed on the stator. This voltage is negative to the voltage provided to the motor and thus is a loss to the overall system. [4]
A permanent magnet synchronous generator is a generator where the excitation field is provided by a permanent magnet instead of a coil. The term synchronous refers here to the fact that the rotor and magnetic field rotate with the same speed, because the magnetic field is generated through a shaft-mounted permanent magnet mechanism, and current is induced into the stationary armature.
Galvanized rigid conduit (GRC) is galvanized steel tubing, with a tubing wall that is thick enough to allow it to be threaded. Its common applications are in commercial and industrial construction. [1] It is designed to protect wire and connectors. Intermediate metal conduit (IMC) is a steel tubing heavier than EMT but lighter than RMC. It may ...
A moving magnet actuator is a type of electromagnetic linear actuator. [1] It typically consists of an arrangement of a mobile permanent magnet and fixed coil, arranged so that currents in the coil generate a pair of equal and opposite forces between the coil and magnet.
The rotor (upper right) has been removed and turned upside-down. The gray ring inside its cup is a permanent magnet. This particular motor is an outrunner, with the stator inside the rotor. DC brushless ducted fan. The two coils on the printed circuit board interact with six round permanent magnets in the fan assembly.
A reluctance motor is a type of electric motor that induces non-permanent magnetic poles on the ferromagnetic rotor. The rotor does not have any windings. It generates torque through magnetic reluctance. Reluctance motor subtypes include synchronous, variable, switched and variable stepping.
[4] [5] A popular example of a magnet motor, although without rotating axis, was put forward by John Wilkins in 1670: A ramp with a magnet at the top, which pulled a metal ball up the ramp. Near the magnet was a small hole that was supposed to allow the ball to drop under the ramp and return to the bottom, where a flap allowed it to return to ...
The magnetic flow meter requires a conducting fluid, for example, water that contains ions, and an electrical insulating pipe surface, for example, a rubber-lined steel tube. If the magnetic field direction were constant, electrochemical and other effects at the electrodes would make the potential difference difficult to distinguish from the ...