Search results
Results from the WOW.Com Content Network
In this way, the transfer case works almost identically to the NV247 transfer case used in the Quadra-Trac II system in 1999 to 2004 WJ Jeep Grand Cherokees. In 4WD Low mode, the clutch pack is locked and power flows through a 2.72:1 planetary gear set for higher torque at lower speeds.
The Dana 300 part-time gear-driven transfer case. [2] That uses a round bolt pattern and has a nearly flat oil pan. It is a heavy-duty, gear-driven transfer case with a 23-spline input shaft. The case is cast iron but the tail housing is aluminum. The ID number C300-15 is stamped on the case.
The TH400 AMC case was used until the end of 1979 model production. The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic. At the time of the acquisition, Kaiser-Jeep was using a GM 2-speed Powerglide transmission in the DJ-5A (with the GM-sourced 2.5L I4).
In North America the NV3550 is used by Jeep with the 4.0L inline 6. It looks similar to and could be mistaken for the Dodge NV3500. However the Jeep NV3550 bellhousing bolts to the transmission case. There are four GM medium duty transmission designs that led to and are often mistaken for the NV3500: 1987 MG-290 MG= Muncie Gear
The Syracuse New Process Gear plant produced transfer cases for all of the "Big Three"—Ford, Chrysler, and General Motors. The NV247 all-wheel drive transfer case, sold by Chrysler's Jeep division as the "Quadra-Trac II," the manual transaxle for the Dodge Neon and PT Cruiser (T-350), and manual transaxles for European-export Chrysler ...
The Jeep Gladiator, Jeep Pickup or J-series is a series of full-size pickup trucks based on the large Jeep SJ platform, which was built and sold under numerous marques from 1962 until 1988. The Jeep Gladiator/Pickup design is noteworthy for remaining in production for more than 26 years on a single automobile platform generation.
Neutral mode is intended for towing the vehicle. In 4-Lo, the front and rear axles are locked together through a 2.72 reduction gear ratio. The NV247 transfer case is mated to front and rear axles containing Jeep's Vari-Lok differentials. Vari-Lok differentials also use a gerotor to transfer torque between the wheels on either side of the axle.
It also gets a locking rear differential and Jeep's Command-Trac 4x4 part-time, two-speed transfer case with a 2.72:1 low-range gear ratio is also standard fare. The Willys Edition has a hood decal, retro-looking 4WD tailgate decal, 17-inch black aluminum wheels with gray pad print, and a gloss black grille.