Search results
Results from the WOW.Com Content Network
Ford — Dual-Stage Intake (DSI), on their Duratec 2.5 and 3.0-litre V6s, and it was also found on the Yamaha V6 in the Taurus SHO. The Ford Modular V8 engines and the V6 Cologne use either the Intake Manifold Runner Control (IMRC) for four-valve engines, or the Charge Motion Control Valve (CMCV) for three-valve engines.
An inlet manifold or intake manifold (in American English) is the part of an internal combustion engine that supplies the fuel/air mixture to the cylinders. [1] The word manifold comes from the Old English word manigfeald (from the Anglo-Saxon manig [many] and feald [repeatedly]) and refers to the multiplying of one (pipe) into many.
The ACIS/TVIS System. Acoustic Control Induction System, or ACIS, is an implementation of a variable-length intake manifold system designed by Toyota.. Simply put, the ACIS system uses a single intake air control valve located in the intake to vary the length of the intake tract in order to optimize power and torque, as well as provide better fuel efficiency and reduce intake "roar".
Alternatively, a manifold vacuum sensor can be used. The manifold vacuum sensor signal, the throttle position, and the crankshaft speed can then be used by the engine control unit to calculate the correct amount of fuel. In modern engines, a combination of all these systems is used. [5]
The intake manifold vacuum, with wide open throttle, is lower in these conditions, which causes the PCV valve to open and the crankcase gases flow to the intake system. [13] The greater flow rate of intake air during these conditions means that a greater quantity of blow-by gases can be added to the intake system without compromising the ...
The n is the number of ports and L the length of the manifold (Fig. 2). This is fundamental of manifold and network models. Thus, a T-junction (Fig. 3) can be represented by two Bernoulli equations according to two flow outlets. A flow in manifold can be represented by a channel network model.
On vehicles so equipped, this alternative involves the use of a manifold absolute pressure, or MAP, sensor. The MAP sensor measures pressure in the engine's inlet manifold. When coupled with data regarding the engine's revolutions per minute, or RPM, and a table of volumetric efficiency over the operating range of the engine, the MAP sensor can ...
Ram-air intake on a Kawasaki ZX-12R. A ram-air intake is any intake design which uses the dynamic air pressure created by vehicle motion, or ram pressure, to increase the static air pressure inside of the intake manifold on an internal combustion engine, thus allowing a greater massflow through the engine and hence increasing engine power.