Search results
Results from the WOW.Com Content Network
Among the earliest representatives of the technology was the OMC Zephyr Saildrive, produced from 1977 to 1984. This was a two-stroke gasoline engine to which oil needed to be added on a 50:1 mixture. It was a derated version of the 32 cubic inch engine block used at that time on the OMC Evinrude 25/30/35 hp outboards.
Placing the cooling radiator section in seawater rather than ambient air allows for the radiator to be smaller. The engine's cooling water may be used directly or indirectly for heating and cooling purposes of the ship. The Stirling engine has potential for surface-ship propulsion, as the engine's larger physical size is less of a concern.
The outdrive resembles the bottom half of an outboard motor and is composed of two sub-units: an upper containing a driveshaft connected through the transom to an engine which transmits power to a 90-degree-angle gearbox; and the lower containing a vertical driveshaft receiving power from the upper unit gearbox, transmitted through another 90 ...
Basic parts of an outboard motor. An outboard motor is a propulsion system for boats, consisting of a self-contained unit that includes engine, gearbox and propeller or jet drive, designed to be affixed to the outside of the transom. They are the most common motorised method of propelling small watercraft.
The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic. At the time of the acquisition, Kaiser-Jeep was using a GM 2-speed Powerglide transmission in the DJ-5A (with the GM-sourced 2.5L I4).
A 16-horsepower (12 kW) inboard marine diesel engine, installed in a sailboat Engine room layout of a rescue boat An 11,100-horsepower (8,300 kW) 5-cylinder, 2-stroke, low-speed marine diesel engine, powering a ship. The first marine craft to utilize inboard motors were steam engines going back to 1805 and the Clermont and the Charlotte Dundas ...
Outboard Marine Corporation (OMC) was a maker of Evinrude, Johnson and Gale Outboard Motors, and many different brands of boats. It was a multibillion-dollar Fortune 500 corporation. [ 1 ] Evinrude began in Milwaukee, Wisconsin in 1907.
The generated vibrations are also compared with the natural frequencies of the different parts/sections and adaptions can be done to the structure. On board, noise travels through the structure (mainly low frequencies), more than through the air, so insulating the engine room is not enough as a way to avoid the noise travelling through the boat ...