Search results
Results from the WOW.Com Content Network
A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.
A valve RF amplifier (UK and Aus.) or tube amplifier is a device for electrically amplifying the power of an electrical radio frequency signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers during the 1960s and 1970s, initially for receivers and low power stages of ...
1R5/DK91 – Pentagrid converter, anode voltage in the 45...90 volt range. 1S4 – Power output pentode Class-A amplifier, anode voltage in the 45...90 volt range. 1S5 – Sharp-cutoff pentode Class-A amplifier, and diode, used as detector and first A.F. stage in battery radio receivers. Anode voltage in the 67...90 volt range.
For a source of 25 kΩ, the noise generated by valve and source are the same, so the total noise power at the output of the amplifier is the square root of two times the noise power at the output of the perfect amplifier. It is not simply double because the noise sources are random and there is some partial cancellation in the combined noise.
The pentode EL84/6BQ5 - 9 pin Noval base tube, that although different enough from the 6V6 not to justify rating it as an equivalent, because of its popularity and ready availability, plus having a close-enough similarity to make it possible, if bias is altered, adapters have been developed commercially to allow an amplifier designed for 6V6 ...
[2] [3] The power gain of the tube is on the order of 40 to 70 decibels, [3] and output power ranges from a few watts to megawatts. [2] [3] TWTs are widely used as the power amplifiers and oscillators in radar systems, communication satellite and spacecraft transmitters, and electronic warfare systems. [2] Diagram of helix TWT
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The pentagrid converter is a type of radio receiving valve (vacuum tube) with five grids used as the frequency mixer stage of a superheterodyne radio receiver. The pentagrid was part of a line of development of valves that were able to take an incoming RF signal and change its frequency to a fixed intermediate frequency , which was then ...