Search results
Results from the WOW.Com Content Network
Water metering is the practice of measuring water use. Water meters measure the volume of water used by residential and commercial building units that are supplied with water by a public water supply system. They are also used to determine flow through a particular portion of the system.
where MTTR is the mean time to repair. The MTTF of a system is the sum of MTTF S and MTTF D. To understand the relationship between MTTF S and MTTF D consider the case of a switch that turns a motor on or off. The switch has two failure modes: the switch can fail stuck closed or the switch can fail stuck open.
Mean time to first failure – Average service life for non-repairable components; Mean time to repair – Measure of the maintainability of repairable items; Power-on hours – The length of time that electrical power is applied to a device; Reliability engineering – Sub-discipline of systems engineering that emphasizes dependability
Mean time to repair (MTTR) is a basic measure of the maintainability of repairable items. It represents the average time required to repair a failed component or device. [ 1 ] Expressed mathematically, it is the total corrective maintenance time for failures divided by the total number of corrective maintenance actions for failures during a ...
Mean time to recovery (MTTR) [1] [2] [3] is the average time that a device will take to recover from any failure. Examples of such devices range from self-resetting fuses (where the MTTR would be very short, probably seconds), to whole systems which have to be repaired or replaced.
This is the most commonly used measurement system for measuring water supply in houses. The fluid, most commonly water, enters in one side of the meter and strikes the nutating disk, which is eccentrically mounted. The disk must then "wobble" or nutate about the vertical axis, since the bottom and the top of the disk remain in contact with the ...
A typical residential water meter A typical residential digital electric submeter Before submetering, many landlords either included the utility cost in the bulk price of the rent or lease , or divided the utility usage among the tenants in some way such as equally, by square footage via allocation methods often called RUBS (Ratio Utility ...
A chart datum is the water level surface serving as origin of depths displayed on a nautical chart and for reporting and predicting tide heights. A chart datum is generally derived from some tidal phase, in which case it is also known as a tidal datum. [1] Common chart datums are lowest astronomical tide (LAT) [1] and mean lower low water (MLLW).