enow.com Web Search

  1. Ads

    related to: step pads 3m for boats plastic wrap sheets 20 pack

Search results

  1. Results from the WOW.Com Content Network
  2. Sheet (sailing) - Wikipedia

    en.wikipedia.org/wiki/Sheet_(sailing)

    A mainsheet is a line connected to the boom which allows a sailor to control the speed of a boat. The jib sheet attaches to the clew of the jib, and controls it. The jib has a sheet on each side, only one of which (the leeward one) will be in use at one time. The spinnaker sheet attaches to the clew(s) of the spinnaker, if carried. A ...

  3. Chine (boating) - Wikipedia

    en.wikipedia.org/wiki/Chine_(boating)

    As the boat's speed increases, hydrodynamic pressure beneath the pad causes the hull to ride higher in the water, so that eventually the boat will be riding solely upon the pad area. At low speeds these hulls ride and handle similarly to a comparable V-hull; but at high speeds the padded hull can both out-accelerate and have a higher top speed ...

  4. Bluejacket 23 - Wikipedia

    en.wikipedia.org/wiki/Bluejacket_23

    The hull, deck and interior liners are integrally molded of multi-laminate fiberglass construction, built by the hand-layup method using polyester resins, 1 ⁄ 2 oz/sq yd (16.95 g/m 2) mat and 24 oz/sq yd (813.7 g/m 2) roving throughout the boat. Positive flotation is provided by large blocks of foam contained inside the cockpit seats and in ...

  5. Thermoplastic - Wikipedia

    en.wikipedia.org/wiki/Thermoplastic

    Polypropylene sheets are used for stationery folders and packaging and clear storage bins. Polypropylene is defined by the recyclable plastic number 5. Although relatively inert, it is vulnerable to ultraviolet radiation and can degrade considerably in direct sunlight. Polypropylene is not as impact-resistant as the polyethylenes (HDPE, LDPE).

  6. Marston Mat - Wikipedia

    en.wikipedia.org/wiki/Marston_mat

    Sometimes the sheets were welded together. A typical later PSP was the M8 landing mat. A single piece weighed about 66 pounds (30 kg) and was 10 ft (3.0 m) long by 15 in (0.38 m) wide. The hole pattern for the sheet was produced to allow easier transportation by aircraft, since it weighed about two-thirds as much.

  7. Combat rubber raiding craft - Wikipedia

    en.wikipedia.org/wiki/Combat_Rubber_Raiding_Craft

    At the bow of the boat are storage bags for equipment (foot pumps, extra lines, etc.) and a special fuel bladder, which can be of either 6- or 18-gallon capacity and which feeds the engine via a flexible hose. Deflated and rolled up, the boat and all necessary equipment can easily fit into the bed of a small pickup.

  1. Ads

    related to: step pads 3m for boats plastic wrap sheets 20 pack