enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Trailer connectors in North America - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   What most of these converters do is to bring together the turn signals and stop lamp signal from a three-wire solution using 54, L and R into a two-wire solution using L54 and R54 according to DIN where brake light and turn indicator uses the same wire and bulb for each side. These converters usually don't handle the case of separate position ...

3. ISO standards for trailer connectors - Wikipedia

   en.wikipedia.org/wiki/ISO_standards_for_trailer...

   Left turn signal: Yellow: 1.5: 15: 4 54: Stop lamps: Red: 1.5: 15: 5 R: Right turn signal: Green: 1.5: 15: 6 58R: Tail lamps, clearance lamps/outline marker lamps, identification lamps and registration plate lamp right side: Brown: 1.5: 15 [ISO1185 1] [ISO1185 2] 7 Trailer brake control according to ISO 1185, SAE J560 use is different: Blue: 1. ...

4. Federal Motor Vehicle Safety Standard 108 - Wikipedia

   en.wikipedia.org/wiki/Federal_Motor_Vehicle...

   When it was initially published in 1968, [10] Motor Vehicle Safety Standard No. 108 was part of 49 CFR 371.21, incorporating several SAE recommended practices by reference. [11] The 1969 version of FMVSS 108 allowed the use of two headlamps, each 7 in (180 mm) in diameter, or four smaller 5 + 3 ⁄ 4 in (150 mm) headlamps. [11]: Table I

5. DIN 72552 - Wikipedia

   en.wikipedia.org/wiki/DIN_72552

   DIN 72552 is a DIN standard for labeling the electric terminals in automotive wiring. The most frequently used labels are listed in the table below. ... flasher unit ...

6. Automotive lighting - Wikipedia

   en.wikipedia.org/wiki/Automotive_lighting

   In vehicles with separate left and right green turn signal tell-tale on the dashboard, both left and right indicators may flash to provide a visual indication of the hazard flashers' operation. In vehicles with a single green turn signal tell-tale on the dashboard, a separate red tell-tale must be provided for hazard flasher indication.

7. List of automotive light bulb types - Wikipedia

   en.wikipedia.org/wiki/List_of_automotive_light...

   Bulbs used for headlamps, turn signals and brake lamps may be required to comply with international and national regulations governing the types of lamps used. Other automotive lighting applications such as auxiliary lamps or interior lighting may not be regulated, but common types are used by many automotive manufacturers.

8. SENT (protocol) - Wikipedia

   en.wikipedia.org/wiki/SENT_(protocol)

   The SENT protocol is a one-way, asynchronous voltage interface which requires three wires: a signal line (low state < 0.5 V, high state > 4.1 V), a supply voltage line (5 V) and a ground line. SENT uses pulse-width modulation to encode four bits (one nibble) per symbol.

9. OBD-II PIDs - Wikipedia

   en.wikipedia.org/wiki/OBD-II_PIDs

   They are both required to be accessed through a standardized data link connector defined by SAE J1962. Heavy duty vehicles (greater than 14,000 lb or 6,400 kg) made after 2010, [1] for sale in the US are allowed to support OBD-II diagnostics through SAE standard J1939-13 (a round diagnostic connector) according to CARB in title 13 CCR 1971.1 ...