Search results
Results from the WOW.Com Content Network
A street lamp mounted on a bracket and column A high pressure sodium street light fixture. Street light interference, sometimes called high voltage syndrome, is the claimed ability of individuals to turn street lights or outside building security lights on or off when passing near them. [1]
They were common on vehicles until the introduction of the flashing amber, red or white indicators at or near the corners of the vehicle (and often along the sides as well), now referred to as "turn-signals". They have been increasingly rare since the 1950s, as ever-stricter legislation has prescribed the need for the modern type of flashing ...
Newer power adapters that are lightweight and are not warm to the touch may use less than one watt. Standby power consumption can be reduced by unplugging or totally switching off, if possible, devices with a standby mode not currently in use; if several devices are used together or only when a room is occupied, they can be connected to a ...
Two light switches in one box. The switch on the right is a dimmer switch. The switch box is covered by a decorative plate. The first light switch employing "quick-break technology" was invented by John Henry Holmes in 1884 in the Shieldfield district of Newcastle upon Tyne. [1]
In New Zealand, where they drive on the left, when a road is given a green light from an all direction stop, a red arrow can continue to display to turning traffic, holding traffic back while the pedestrian crossing on the side road is given a green signal (for left turns) or while oncoming traffic goes straight ahead and there is no permissive right turn allowed (for right turns).
A twilight switch is an electronic component that allows the automatic activation of a lighting circuit when natural light drops in a given environment. Among a large number of uses, the most common is to enable automatic lighting of streets, roads, highways, roads, gardens, courtyards, etc., when sunlight drops below a certain level (e.g.: a ...
Watching the lights allows one to follow the instructions and the changing data as it runs the Squares program displayed on the panels. In computer jargon, blinkenlights are diagnostic lights on front panels of old mainframe computers. More recently the term applies to status lights of modern network hardware (modems, network hubs, etc.). [1]
In contrast to a simple light switch, which is a single pole, single throw (SPST) switch, multiway switching uses switches with one or more additional contacts and two or more wires are run between the switches. When the load is controlled from only two points, single pole, double throw (SPDT) switches are used.