enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Servo (radio control) - Wikipedia

   en.wikipedia.org/wiki/Servo_(radio_control)

   The servo is controlled by three wires: ground, power, and control. The servo will move based on the pulses sent over the control wire, which set the angle of the actuator arm. The servo expects a pulse every 20 ms in order to gain correct information about the angle. The width of the servo pulse dictates the range of the servo's angular motion.

3. Direct-drive sim racing wheel - Wikipedia

   en.wikipedia.org/wiki/Direct-drive_sim_racing_wheel

   The types of motors used vary between high-end 3-phase brushless servomotors [14] and lower budget hybrid stepper-servo motors. [1] In-runner servo motors are typically smoother and more expensive than stepper or outrunner motors. [15] Outrunner motors typically can produce more torque than inrunner motors, [16] but need more cooling at higher ...

4. Servo control - Wikipedia

   en.wikipedia.org/wiki/Servo_control

   Servo and receiver connections A diagram showing typical PWM timing for a servomotor. Servo control is a method of controlling many types of RC/hobbyist servos by sending the servo a PWM (pulse-width modulation) signal, a series of repeating pulses of variable width where either the width of the pulse (most common modern hobby servos) or the duty cycle of a pulse train (less common today ...

5. Servomotor - Wikipedia

   en.wikipedia.org/wiki/Servomotor

   A servomotor (or servo motor or simply servo) [1] is a rotary or linear actuator that allows for precise control of angular or linear position, velocity, and acceleration in a mechanical system. [ 1 ] [ 2 ] It constitutes part of a servomechanism , and consists of a suitable motor coupled to a sensor for position feedback and a controller ...

6. Servomechanism - Wikipedia

   en.wikipedia.org/wiki/Servomechanism

   A standard RC receiver (or a microcontroller) sends pulse-width modulation (PWM) signals to the servo. The electronics inside the servo translate the width of the pulse into a position. When the servo is commanded to rotate, the motor is powered until the potentiometer reaches the value corresponding to the commanded position.

7. High performance positioning system - Wikipedia

   en.wikipedia.org/wiki/High_performance...

   HPPS, driven by linear motors, can move at a combined high velocity on order of 3-5 m/s, high accelerations of 5-7 g, at micron or sub micron positioning accuracy with settling times on order of milliseconds and servo bandwidth of 30-50 Hz. Ball screw actuators, on the other hand, have typical bandwidth of 10-20 Hz and belt driven actuators at ...