Search results
Results from the WOW.Com Content Network
Port triggering is a configuration option on a NAT-enabled router that controls communication between internal and external host machines in an IP network. It is similar to port forwarding in that it enables incoming traffic to be forwarded to a specific internal host machine, although the forwarded port is not open permanently and the target internal host machine is chosen dynamically.
Port forwarding via NAT router. In computer networking, port forwarding or port mapping is an application of network address translation (NAT) that redirects a communication request from one address and port number combination to another while the packets are traversing a network gateway, such as a router or firewall.
This field is meaningful only in Membership Query; in other messages, it is set to 0 and ignored by the receiver. The field specifies time in units of 0.1 second (a field value of 10 specifies 1 second). Larger values reduce IGMP traffic burstiness and smaller values improve protocol responsiveness when the last host leaves a group. [8]: §2.2
As an example, assume the case of Wake-on-LAN. Traditionally, the OS controls Wake-on-LAN and must call third-party device drivers to enable support on a network card. With the HECI bus, the host is able to assert its request line (REQ#), the ME will assert its grant line (GNT#), and the host can send its message using its serial transmit signal.
In other textbooks, [1] the term socket refers to a local socket address, i.e. a "combination of an IP address and a port number". In the original definition of socket given in RFC 147, [ 2 ] as it was related to the ARPA network in 1971, "the socket is specified as a 32-bit number with even sockets identifying receiving sockets and odd sockets ...
The application first sets up its access to the CAN interface by initialising a socket (much like in TCP/IP communications), then binding that socket to an interface (or all interfaces, if the application so desires). Once bound, the socket can then be used like a UDP socket via read, write, etc... Python added support for SocketCAN in version ...
Dante is a circuit-level SOCKS server that can be used to provide convenient and secure network connectivity, requiring only the host Dante runs on to have external network connectivity. [ 19 ] HevSocks5Server is a high-performance and low-overhead SOCKS server for Unix (Linux/BSD/macOS).
After instantiating a new socket, the server binds the socket to an address. For a Unix domain socket, the address is a /path/filename.. Because the socket address may be either a /path/filename or an IP_address:Port_number, the socket application programming interface requires the address to first be set into a structure.