enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Schmitt trigger - Wikipedia

    en.wikipedia.org/wiki/Schmitt_trigger

    There is a close relation between the two kinds of circuits: a Schmitt trigger can be converted into a latch and a latch can be converted into a Schmitt trigger. Schmitt trigger devices are typically used in signal conditioning applications to remove noise from signals used in digital circuits, particularly mechanical contact bounce in switches.

  3. List of 4000-series integrated circuits - Wikipedia

    en.wikipedia.org/wiki/List_of_4000-series...

    The following is a list of CMOS 4000-series digital logic integrated circuits.In 1968, the original 4000-series was introduced by RCA.Although more recent parts are considerably faster, the 4000 devices operate over a wide power supply range (3V to 18V recommended range for "B" series) and are well suited to unregulated battery powered applications and interfacing with sensitive analogue ...

  4. List of 7400-series integrated circuits - Wikipedia

    en.wikipedia.org/wiki/List_of_7400-series...

    Schmitt trigger three-state 14 SN74LS242: 74x243 4 quad bus transceiver, non-inverting outputs Schmitt trigger three-state 14 SN74LS243: 74x244 8 octal buffer, non-inverting outputs Schmitt trigger three-state 20 SN74LS244: 74x245 8 octal bus transceiver, non-inverting outputs Schmitt trigger three-state 20 SN74LS245: 74x246 1

  5. Regenerative circuit - Wikipedia

    en.wikipedia.org/wiki/Regenerative_circuit

    One example is the Schmitt trigger (which is also known as a regenerative comparator), but the most common use of the term is in RF amplifiers, and especially regenerative receivers, to greatly increase the gain of a single amplifier stage. [4] [5] [6]

  6. 4000-series integrated circuits - Wikipedia

    en.wikipedia.org/wiki/4000-series_integrated...

    A very early CD4029A counter IC, in 16-pin ceramic dual in-line package (DIP-16), manufactured by RCA Colorized IC die and schematics of CD4011BE NAND gateThe 4000 series was introduced as the CD4000 COS/MOS series in 1968 by RCA [1] as a lower power and more versatile alternative to the 7400 series of transistor-transistor logic (TTL) chips.

  7. Triggering device - Wikipedia

    en.wikipedia.org/wiki/Triggering_device

    A Triggering device is an electronic circuit, such as a Schmitt trigger, which is used to control another electronic circuit. Uses In many of industrial operations ...

  8. Flip-flop (electronics) - Wikipedia

    en.wikipedia.org/wiki/Flip-flop_(electronics)

    Q = 1 (1, 0) – referred to as an S (dominated)-latch; Q = 0 (0, 1) – referred to as an R (dominated)-latch; This is done in nearly every programmable logic controller. Hold state (0, 0) – referred to as an E-latch; Alternatively, the restricted combination can be made to toggle the output. The result is the JK latch.

  9. Power-on reset - Wikipedia

    en.wikipedia.org/wiki/Power-on_reset

    One of the issues with using an RC network to generate a PoR pulse is the sensitivity of the R and C values to the power-supply ramp characteristics. When the power supply ramp is rapid, the R and C values can be calculated so that the time to reach the switching threshold of the Schmitt trigger is enough to apply a long enough reset pulse.