Search results
Results from the WOW.Com Content Network
All propellers produce a transverse thrust, also called screwing effect or starting bias, which gives a tendency for end of ship to move sideways. In a twin-screw ships the port propeller is usually left-handed and the starboard right-handed, to cancel out the transverse thrust and avoid propeller walk. [2]
A screw steamer or screw steamship (abbreviated "SS") is an old term for a steamship or steamboat powered by a steam engine, using one or more propellers (also known as screws) to propel it through the water. Such a ship was also known as an "iron screw steam ship".
TSS Earnslaw is a 1912 Edwardian twin screw steamer based at Lake Wakatipu in New Zealand. She is one of the oldest tourist attractions in Central Otago , and the only remaining commercial passenger-carrying coal-fired steamship in the southern hemisphere.
While smaller vessels tend to have a single screw, even very large ships such as tankers, container ships and bulk carriers may have single screws for reasons of fuel efficiency. Other vessels may have twin, triple or quadruple screws. Power is transmitted from the engine to the screw by way of a propeller shaft, which may be connected to a ...
A screw turning through a solid will have zero "slip"; but as a propeller screw operates in a fluid (either air or water), there will be some losses. The most efficient propellers are large-diameter, slow-turning screws, such as on large ships; the least efficient are small-diameter and fast-turning (such as on an outboard motor).
The picket boat of the Royal Navy, (also sometimes called a P1000) was a twin screw boat in use at Britannia Royal Naval College in Dartmouth primarily to train officer cadets in boat handling and seamanship.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The Z-drive is so named because of the appearance (in cross section) of the mechanical driveshaft or transmission configuration used to connect the mechanically supplied driving energy to the Z-drive azimuth thruster device. This form of power transmission is called a Z-drive because the rotary motion has to make two right angle turns, thus ...