Search results
Results from the WOW.Com Content Network
The only terminal remaining is the source. This is a common-source FET circuit. The analogous bipolar junction transistor circuit may be viewed as a transconductance amplifier or as a voltage amplifier. (See classification of amplifiers). As a transconductance amplifier, the input voltage is seen as modulating the current going to the load.
In electronics engineering, frequency compensation is a technique used in amplifiers, and especially in amplifiers employing negative feedback.It usually has two primary goals: To avoid the unintentional creation of positive feedback, which will cause the amplifier to oscillate, and to control overshoot and ringing in the amplifier's step response.
Like a standard operational amplifier, the OTA also has a high impedance differential input stage and may be used with negative feedback. [3] But the OTA differs in that: The OTA outputs a current while a standard operational amplifier outputs a voltage. The OTA is usually used "open-loop"; without negative feedback in linear applications.
Figure 2: A negative-feedback amplifier. The circuit can be explained by viewing the transistor as being under the control of negative feedback.From this viewpoint, a common-collector stage (Fig. 1) is an amplifier with full series negative feedback.
Feedback-free instrumentation amplifier is the high-input-impedance differential amplifier designed without the external feedback network. This allows reduction in the number of amplifiers (one instead of three), reduced noise (no thermal noise is brought on by the feedback resistors) and increased bandwidth (no frequency compensation is needed).
Charge amplifier for piezoelectric sensors. Practical charge amplifiers usually include additional stages like voltage amplifiers, transducer sensitivity adjustment, high and low pass filters, integrators and level monitoring circuits. The charge signals at the input of a charge amplifier can be as low as some fC (FemtoCoulomb = 10 −15 C). A ...
A regenerative circuit is an amplifier circuit that employs positive feedback (also known as regeneration or reaction). [ 1 ] [ 2 ] Some of the output of the amplifying device is applied back to its input to add to the input signal, increasing the amplification. [ 3 ]
For R S values in the vicinity of r E the amplifier is transitional between voltage amplifier and current buffer. For R S ≫ r E the driver representation as a Thévenin source should be replaced by representation with a Norton source. The common base circuit stops behaving like a voltage amplifier and behaves like a current follower, as ...