Search results
Results from the WOW.Com Content Network
The Aurora had the 4.0L version of the Northstar V8 coupled to a 4T80-E. It wasn't until 2004 that Pontiac got usage of this transaxle in the Bonneville GXP which employed a 275 horsepower version of the Northstar 4.6L V8. The 4T80-E was last used in 2011 on the Cadillac DTS and the Buick Lucerne (when equipped with the 4.6L Northstar). [7 ...
This same transmission is used in the Saturn Vue Green Line hybrid vehicle with the addition of an auxiliary oil pump and hybrid-aware electronics. It is designed for 3.0–3.5 L engines producing up to 205 ft·lbf (278 N·m) of torque, but was also commonly mated to some versions of GM's 4-cylinder Ecotec line.
This engine features a square 83 mm (3.27 in) bore and stroke with a 10.0:1 compression ratio. This engine was built at the Trenton Engine Plant for use in export market (non-US) Chrysler Neons. It produces 86 kW (115 hp) at 5750 rpm and 151 N⋅m (111 lb⋅ft) at 4950 rpm and meets Euro III emission standards. Applications:
The Northstar engine is a family of high-performance 90° V engines produced by General Motors between 1993 and 2011. Regarded as GM's most technically complex engine, the original double overhead cam, four valve per cylinder, aluminum block/aluminum head V8 design was developed by Oldsmobile R&D, [citation needed] but is most associated with Cadillac's Northstar series.
Four-stroke cycle used in gasoline/petrol engines: intake (1), compression (2), power (3), and exhaust (4). The right blue side is the intake port and the left brown side is the exhaust port. The cylinder wall is a thin sleeve surrounding the piston head which creates a space for the combustion of fuel and the genesis of mechanical energy.
It was the first V8 engine with a single-engine block casting, putting a V8 into an affordable car for the first time. [4] The communal water jacket of monobloc designs permitted closer spacing between cylinders. The monobloc design approach also improved engines' torsional rigidity as cylinder numbers, engine lengths, and power ratings increased.
This engine is also known as a A28NET, Z28NET, Z28NEL or B284. The LP9 is a 2.8L turbocharged version used for the Saab 9-3, Saab 9-5, and other GM vehicles. It has the same bore and stroke as the naturally aspirated LP1, however the compression ratio is reduced to 9.5:1. The engine is manufactured at Holden's Fishermans Bend engine factory in ...
242 cu in (4.0 L) The early engines' bell pattern differed from AMC V8s. In 1971 AMC raised the block height and lengthened the stroke on the 199 and early 232 engines. The 199 became 232 cubic inches and the 232 became 258. These two RB or "raised block" engines shared the small bell pattern of the earlier engines for only the 1971 model year.