Search results
Results from the WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Some simple vehicle designs, such as leisure go-karts, may have a single driven wheel where the drive axle is a split axle with only one of the two shafts driven by the engine, or else have both wheels connected to one shaft without a differential (kart racing). However, other go-karts have two rear drive wheels too.
Children's toys and go-karts often use a very direct linkage in the form of a bellcrank (also commonly known as a pitman arm) attached directly between the steering column and the steering arms, and the use of cable-operated steering linkages (e.g. the capstan and bowstring mechanism) is also found on some home-built vehicles such as soapbox ...
K1 Speed is an American go-kart racetrack franchise based in Irvine, California. [1] The company was co-founded in 2003 by David Danglard and Susan Danglard, who had previously worked in the fashion industry. [2] [3] That same year, K1 Speed opened their first go-kart track outside San Diego, California. [1]
Other measures include lightweight aluminium wheels to reduce the unsprung mass of the wheel assembly; vehicle designs may be optimized to lower the centre of gravity by locating heavier elements (including battery) at floor level; In a typical road vehicle the power-transmission setup may be smaller and lighter than the equivalent conventional ...
Optical fibers are used by utilities as an alternative to private point to point microwave systems, power line carrier or communication circuits on metallic cables. OPGW as a communication medium has some advantages over buried optical fiber cable. Installation cost per kilometre is lower than a buried cable.
An electric go-kart is a type of go-kart powered by electric motors and batteries or supercapacitors, as opposed to a traditional petrol engine. As of 2022, electric go-karts are mostly used for rental go-karts for recreational usage. For serious kart racing, traditional 2-stroke petrol engines are mostly used, but development of high ...
One of the earliest hydraulic dampers to go into production was the Telesco Shock Absorber, exhibited at the 1912 Olympia Motor Show and marketed by Polyrhoe Carburettors Ltd. [3] This contained a spring inside the telescopic unit like the pure spring type 'shock absorbers' mentioned above, but also oil and an internal valve so that the oil ...