enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hose clamp - Wikipedia

   en.wikipedia.org/wiki/Hose_clamp

   Screw clamps are normally used for hoses 1/2 inch diameter and up, with other clamps used for smaller hoses. The first patent for a worm-drive hose clamp was granted to Swedish inventor Knut Edwin Bergström [ se ] in 1896 [ 2 ] Bergström founded “Allmänna Brandredskapsaffären E. Bergström & Co.” in 1896 (ABA) to manufacture these worm ...

3. Width across flats - Wikipedia

   en.wikipedia.org/wiki/Width_across_flats

   A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 21 ] : 149 [ 18 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...

5. Barrel threads - Wikipedia

   en.wikipedia.org/wiki/Barrel_threads

   Clamp coupling. [52] The clamping section is 36.5 mm long. The clamping portion of the 202 is somewhat shorter, such that 200 STR barrels can be used in the 202 without modifications (but not necessarily the other way around). 1.063" Sauer 303 ⌀__mm N/A N/A Clamp coupling. Sauer 404 ⌀__mm N/A N/A Clamp coupling. Jalonen JJ-92A [15] M27 1.5 ...

6. Bolted joint - Wikipedia

   en.wikipedia.org/wiki/Bolted_joint

   The curve representing a clamped parts-to-bolt stiffness ratio of 0.01 shows that when the relative stiffness of the clamped parts is very low, almost all of the load is transferred to the bolt, down to the point where a compressive load equals the preload, and separation at the bolt head occurs, reducing the force in the bolt to zero.

7. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Flat-blade jeweler's screwdrivers and the tips found in 1 ⁄ 4-inch or 6.4-millimeter drive sets are generally hollow-ground. Note that it is this typical chisel shape which allows 9 screwdriver sizes to drive 24 different slotted screw sizes, with the drawbacks of not fitting as closely as a hollow-ground screwdriver would, and increasing the ...