Search results
Results from the WOW.Com Content Network
A segment can be extended by allocating another memory page and adding it to the segment's page table. An implementation of virtual memory on a system using segmentation with paging usually only moves individual pages back and forth between main memory and secondary storage, similar to a paged non-segmented system.
If paging is enabled, the base address in a segment descriptor is an address in a linear paged address space divided into 4 KB pages, so when that is added to the offset in the segment, the resulting address is a linear address in that address space; in IA-32, that address is then masked to be no larger than 32 bits. The result may be looked up ...
Without paging support the segment is the physical unit swapped in and out of memory if required. With paging support the pages are usually the unit of swapping and segmentation only adds an additional level of security. Addresses in a segmented system usually consist of the segment id and an offset relative to the segment base address, defined ...
When pure demand paging is used, pages are loaded only when they are referenced. A program from a memory mapped file begins execution with none of its pages in RAM. As the program commits page faults, the operating system copies the needed pages from a file, e.g., memory-mapped file, paging file, or a swap partition containing the page data ...
If the paging unit is enabled, addresses in a segment are now virtual addresses, rather than physical addresses as they were on the 80286. That is, the segment starting address, the offset, and the final 32-bit address the segmentation unit derived by adding the two are all virtual (or logical) addresses when the paging unit is enabled.
Flat memory model or linear memory model refers to a memory addressing paradigm in which "memory appears to the program as a single contiguous address space." [1] The CPU can directly (and linearly) address all of the available memory locations without having to resort to any sort of bank switching, memory segmentation or paging schemes.
The term "segment" comes from the memory segment, which is a historical approach to memory management that has been succeeded by paging.When a program is stored in an object file, the code segment is a part of this file; when the loader places a program into memory so that it may be executed, various memory regions are allocated (in particular, as pages), corresponding to both the segments in ...
Four registers are used to refer to four segments on the 16-bit x86 segmented memory architecture. DS (data segment), CS (code segment), SS (stack segment), and ES (extra segment). Another 16-bit register can act as an offset into a given segment, and so a logical address on this platform is written segment:offset, typically in hexadecimal ...