Search results
Results from the WOW.Com Content Network
A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.
A motor control center (MCC) is an assembly to control some or all electric motors in a central location. It consists of multiple enclosed sections having a common power bus and with each section containing a combination starter, which in turn consists of motor starter , fuses or circuit breaker , and power disconnect . [ 1 ]
Daily load diagram; Blue shows real load usage and green shows ideal load. Load management , also known as demand-side management ( DSM ), is the process of balancing the supply of electricity on the network with the electrical load by adjusting or controlling the load rather than the power station output.
Load affects the performance of circuits with respect to output voltages or currents, such as in sensors, voltage sources, and amplifiers. Mains power outlets provide an easy example: they supply power at constant voltage, with electrical appliances connected to the power circuit collectively making up the load.
There may also be instruments and controls for the supply of electricity to the switchboard. For example, a switchboard for a bank of electrical generators, especially frequency would have control of AC power and load sharing, and instruments for frequency, voltage, current, and energy, with perhaps a synchroscope. A main switchboard is a large ...
An electrical drawing is a type of technical drawing that shows information about power, lighting, and communication for an engineering or architectural project.Any electrical working drawing consists of "lines, symbols, dimensions, and notations to accurately convey an engineering's design to the workers, who install the electrical system on the job".
The PDC housing contains a transformer, which steps down the incoming power to a lower voltage to feed other plant loads such as motor control centers (MCC's). Feeder breakers for these loads will be located on the PDC. PDC's will often contain additional protective relays, monitoring equipment, fuses, terminal points, etc...
The transformers are wired together on the secondary side. The system is arranged so that nearby transformers do not use the same feeder. In case of an issue with a feeder (or transformer) the load is fed by nearby transformers, so there is no interruption, although a voltage drop for said load may then be present.