Search results
Results from the WOW.Com Content Network
Short forms, up to 60 cm high, are placed on both sides of the wall to serve as a guide for the stone work. The stones are placed inside the forms with the good faces against the form work. Concrete is poured in behind the rocks. Rebar is added for strength, to make a wall that is approximately half reinforced concrete and half stonework. The ...
Precise offsite dimension cuts. Precutting can be done at the quarry, or at a masonry workshop by sawyer and banker masons. The precision amounts to a form of prefabrication, such that the masons do not have to make adjustments onsite, and construction is an assembly process. Precise ashlar interfaces also reduce the amount of mortar required. [22]
Rustication is a range of masonry techniques used in classical architecture giving visible surfaces a finish texture that contrasts with smooth, squared-block masonry called ashlar. The visible face of each individual block is cut back around the edges to make its size and placing very clear.
True polygonal masonry is a technique wherein the visible surfaces of the stones are dressed with straight sides or joints, giving the block the appearance of a polygon. [ 1 ] This technique is found throughout the world and sometimes corresponds to the less technical category of Cyclopean masonry .
Harling as a process covers stonework using a plastering process involving a slurry of small pebbles or fine chips of stone. After a wall is complete and has been pointed and allowed to cure then a base of lime render is applied to the bare stone. While this render is still wet a specially shaped trowel is used to throw the pebbles onto the ...
Masonry chisels are used for the general shaping of stones. Stone point tools are used to rough out the surface of the stone. Stone claw tools are used to remove the peaks and troughs left from the previously used tools. Stone pitching tools are used to remove large quantities of stone.
The thickness and width of a tuckpointing tool common ranges from 1 millimetre (0.039 in) to 14 millimetres (0.55 in). The thickness and width of these tools are dependent upon the mason's preference and the type of brick or stonework they are tuckpointing. [citation needed] Wider tools are often used when tuckpointing stonework. [citation needed]
different mallets and pitching tool Roughed out carvings This shows the process of "pointing", the traditional method of making exact copies in stone carving. A point machine is used to measure points on the original sculpture (seen on the right) and transfer those points onto the stone copy (left).