Search results
Results from the WOW.Com Content Network
Once the coolant absorbs the heat from the engine it continues its flow to the radiator. The radiator transfers heat from the coolant to the passing air. Radiators are also used to cool automatic transmission fluids, air conditioner refrigerant, intake air, and sometimes to cool motor oil or power steering fluid. A radiator is typically mounted ...
Bleed screws are not common on cars today and are only necessary when design of an engine's cooling system results in areas where air can be trapped in the system. [citation needed] Air in the system can lead to overheating of the engine and in modern cars also to poor vehicle operation (e.g. problems with the AC system or incorrect engine idle).
The AOL.com video experience serves up the best video content from AOL and around the web, curating informative and entertaining snackable videos.
Core plugs can often be a source of leaks due to corrosion caused by cooling system water. [4] Although modern antifreeze chemicals do not evaporate and may be considered "permanent", anti-corrosion additives gradually deplete and must be replenished via a flush and refill. Automotive manufacturers specify time and mileage numbers for cooling ...
A heater core is a radiator-like device used in heating the cabin of a vehicle. Hot coolant from the vehicle's engine is passed through a winding tube of the core, a heat exchanger between coolant and cabin air. Fins attached to the core tubes serve to increase surface area for heat transfer to air that is forced past them by a fan, thereby ...
Proper engine coolant and a pressurized coolant system obviate these shortcomings of water. With proper antifreeze, a wide temperature range can be tolerated by the engine coolant, such as −34 °F (−37 °C) to +265 °F (129 °C) for 50% (by volume) propylene glycol diluted with distilled water and a 15 psi pressurized coolant system.
The temperature of the cooling air may range from well below freezing to 50 °C. Further, while engines in long-haul boat or rail service may operate at a steady load, road vehicles often see widely varying and quickly varying load. Thus, the cooling system is designed to vary cooling so the engine is neither too hot nor too cold.
The hot coolant is then fed into the inlet tank of the radiator (located either on the top of the radiator, or along one side), from which it is distributed across the radiator core through tubes to another tank on the opposite end of the radiator. As the coolant passes through the radiator tubes on its way to the opposite tank, it transfers ...