Search results
Results from the WOW.Com Content Network
MIL-STD-498 standard describes the development and documentation in terms of 22 Data Item Descriptions (DIDs), which were standardized documents for recording the results of each the development and support processes, for example, the Software Design Description DID was the standard format for the results of the software design process.
MIL-STD 461, "Requirements for the control of electromagnetic interference characteristics of subsystems and equipment" [18] MIL-STD-464, "Electromagnetic Environmental Effects Requirements for Systems" [19] MIL-STD-498, on software development and documentation [20] MIL-STD-499, on Engineering Management (System Engineering)
MIL-STD-498. RTCA DO-178. DOD-STD-2167A (Department of Defense Standard 2167A), titled "Defense Systems Software Development", was a United States defense standard, published on February 29, 1988, which updated the less well known DOD-STD-2167 published 4 June 1985. This document established "uniform requirements for the software development ...
A United States data item description (DID) is a completed document defining the data deliverables required of a United States Department of Defense contractor. [1] A DID specifically defines the data content, format, and intended use of the data with a primary objective of achieving standardization objectives by the U.S. Department of Defense.
ISO/IEC/IEEE 12207 Systems and software engineering – Software life cycle processes [1] is an international standard for software lifecycle processes. First introduced in 1995, it aims to be a primary standard that defines all the processes required for developing and maintaining software systems, including the outcomes and/or activities of each process.
It is preferred that articles in this category be listed by publishing identifier (MIL-STD-####) for consistency. Pages in category "Military of the United States standards" The following 46 pages are in this category, out of 46 total.
My first work with DO-178B was with a number of manufactures who were transitioning from MIL-STD-498 to DO-178B, or with clients that had already made the transition, but retained certain MIL-STD-498 notations. The impression was that DO-178B followed MIL-STD-498, but, in reality DO-178B (1992) preceded MIL-STD-498 (1994).
MIL-STD-810 is maintained by a Tri-Service partnership that includes the United States Air Force, Army, and Navy. [2] The U.S. Army Test and Evaluation Command, or ATEC, serves as Lead Standardization Activity / Preparing Activity, and is chartered under the Defense Standardization Program (DSP) with maintaining the functional expertise and serving as the DoD-wide technical focal point for the ...