Search results
Results from the WOW.Com Content Network
As Unicode included all the characters in the MSDOS code pages, this had the immediate benefit that all the old MSDOS Alt combinations worked, not just the ones that existed in the Windows Code Page. In the IBM PC Bios typing an Alt code greater than 255 produced the same as that number modulo 256. [ 3 ]
4 Line feed is used for "end of line" in text files on Unix / Linux systems. 5 Carriage Return (accompanied by line feed) is used as "end of line" character by Windows, DOS, and most minicomputers other than Unix- / Linux-based systems 6 Control-O has been the "discard output" key. Output is not sent to the terminal, but discarded, until ...
To use alt key codes for keyboard shortcut symbols you’ll need to have this enabled. If you’re using a laptop, your number pad is probably integrated to save space. No problem! Just hit the Fn ...
On many Unix systems and early dial-up bulletin board systems the only common standard for box-drawing characters was the VT100 alternate character set (see also: DEC Special Graphics). The escape sequence Esc ( 0 switched the codes for lower-case ASCII letters to draw this set, and the sequence Esc ( B switched back:
A legacy of code page 437 is the number combinations used in Windows Alt codes. [6] [7] [8] A DOS user could enter a character by holding down the Alt key and entering the character code on the numpad [6] and many users memorized the numbers needed for CP437 (or for the similar CP850).
The most common superscript digits (1, 2, and 3) were included in ISO-8859-1 and were therefore carried over into those code points in the Latin-1 range of Unicode. The remainder were placed along with basic arithmetical symbols, and later some Latin subscripts, in a dedicated block at U+2070 to U+209F.
The Egyptian Hieroglyphs Unicode block has 94 standardized variants defined to specify rotated signs: [3] [4]. Variation selector-1 (VS1) (U+FE00) can be used to rotate 40 signs by 90°:
Following is a list of code names that have been used to identify computer hardware and software products while in development. In some cases, the code name became the completed product's name, but most of these code names are no longer used once the associated products are released.