Search results
Results from the WOW.Com Content Network
The Cheng cycle is a simplified form of combined cycle where the steam turbine is eliminated by injecting steam directly into the combustion turbine. This has been used since the mid 1970s and allows recovery of waste heat with less total complexity, but at the loss of the additional power and redundancy of a true combined cycle system.
Large (land-based) electric powerplants built using this combined cycle can reach conversion efficiencies of over 60%. [ 1 ] If the turbines do not drive a propeller shaft directly and instead a turbo-electric transmission is used, the system is known as COGES (combined gas turbine-electric and steam).
Gas turbine plus steam turbine (combined cycle) Chemical to thermal+electrical (cogeneration) up to 63.08% [14] In December 2017, GE claimed >64% in its latest 826 MW 9HA.02 plant, up from 63.7%. They said this was due to advances in additive manufacturing and combustion. Their press release said that they planned to achieve 65% by the early 2020s.
Cogeneration or combined heat and power (CHP) is the use of a heat engine [1] or power station to generate electricity and useful heat at the same time. Cogeneration is a more efficient use of fuel or heat, because otherwise-wasted heat from electricity generation is put to some productive use.
Emissions controls may also be located in the HRSG. Some may contain a selective catalytic reduction system to reduce nitrogen oxides (a large contributor to the formation of smog and acid rain) or a catalyst to remove carbon monoxide. The inclusion of an SCR dramatically affects the layout of the HRSG.
The woman who pleaded guilty to dressing as a clown and fatally shooting the wife of a man she later would marry has been released from prison, according to Florida Department of Corrections ...
General Motors is adding over 132,000 heavy-duty pickups in the U.S. to a previous recall for tailgate release switches that can short circuit and open the gates while the trucks are in park. The ...
Load-following power plants can be hydroelectric power plants, diesel and gas engine power plants, combined cycle gas turbine power plants and steam turbine power plants that run on natural gas or heavy fuel oil, although heavy fuel oil plants make up a very small portion of the energy mix. A relatively efficient model of gas turbine that runs ...