Search results
Results from the WOW.Com Content Network
Part 1-1: General – Rules for reinforced and unreinforced masonry structures (EN 1996-1-1) Part 1-2: General rules – Structural fire design (EN 1996-1-2) Part 2: Design, selection of materials and execution of masonry (EN 1996-2) Part 3: Simplified calculation methods for unreinforced masonry structures (EN 1996-3)
The compressive strength of concrete blocks and masonry walls varies from approximately 3.4 to 34.5 MPa (500–5,000 psi) based on the type of concrete used to manufacture the unit, stacking orientation, the type of mortar used to build the wall, and whether it is a load-bearing partition or not, among other factors. [18] [19] [20] [21]
Coursed masonry construction arranges units in regular courses. Oppositely, coursed rubble masonry construction uses random uncut units, infilled with mortar or smaller stones. [1] If a course is the horizontal arrangement, then a wythe is a continuous vertical section of masonry [2] one unit in thickness. A wythe may be independent of, or ...
EN 1996-1-2 deals with the design of masonry structures for the accidental situation of fire exposure, and is intended to be used in conjunction with EN 1996-1-1, EN 1996-2, 1996-3 and EN 1991-1-2. This part only identifies differences from, or supplements to, normal temperature design and it deals only with passive methods of fire protection.
4-inch (100 mm) hollow CMU (concrete masonry unit) [34] 45 Double layer of 1 ⁄ 2-inch (13 mm) drywall on each side, wood studs, batt insulation in wall 46 Single layer of 1 ⁄ 2-inch (13 mm) drywall, glued to 6-inch (150 mm) lightweight concrete block wall, painted both sides 46 6-inch (150 mm) hollow CMU (concrete masonry unit) [34] 48
A single wythe of brick that is not structural in nature is referred to as a masonry veneer. A multiple-wythe masonry wall may be composed of a single type of masonry unit layered to increase its thickness and structural strength, or different masonry units chosen by function, such as an economical concrete block serving a structural purpose ...
Clay masonry units – Part 1: Solid and hollow bricks with density classes of 1,2: Withdrawn: DIN V 105-100, DIN EN 771-1: EN 771-1: DIN V 105-2: Clay masonry units – Part 2: Solid and hollow bricks with density classes equal 1.0: Withdrawn: DIN V 105-100, DIN EN 771-1: EN 771-1: DIN 105-3: Clay masonry units – Part 3: Tile and high ...
Concrete masonry units (CMUs) or blocks in a basement wall before burial. Blocks of cinder concrete (cinder blocks or breezeblocks), ordinary concrete (concrete blocks), or hollow tile are generically known as Concrete Masonry Units (CMUs). They usually are much larger than ordinary bricks and so are much faster to lay for a wall of a given size.