Search results
Results from the WOW.Com Content Network
An attenuator is a passive broadband electronic device that reduces the power of a signal without appreciably distorting its waveform. An attenuator is effectively the opposite of an amplifier, though the two work by different methods. While an amplifier provides gain, an attenuator provides loss, or gain less than unity. An attenuator is often ...
The audio signal goes to a 4.5 MHz amplifier. This amplifier prepares the signal for the 4.5 MHz detector. It then goes through a 4.5 MHz IF transformer to the detector. In television, there are 2 ways of detecting FM signals. One way is by the ratio detector. This is simple but very hard to align. The next is a relatively simple detector.
It is possible to also get a bad picture if the signal strength of the TV transmitter is too high. An attenuator inserted in the antenna lead-in wire may be used if the television receiver displays signs of overload in the RF front end. Strong out-of-band signals may also affect television reception and may require band-pass filters to reduce ...
Most cable companies require a set-top box (cable converter box) or a slot on one's TV set for conditional access module cards [2] to view their cable channels, even on newer televisions with digital cable QAM tuners, because most digital cable channels are now encrypted, or scrambled, to reduce cable service theft. A cable from the jack in the ...
CEA-608-B specifies meaning of the 7-bit field placed on the data lines. The bits 4 and 3 contain the CGMS-A values, the bits 2 and 1 contain the Analog Protection System (APS) value, the bit 0 is the Analog Source Bit (ASB) specifying if the signal originates from a pre-recorded material, bits 5 and 6 are reserved.
A simulated example of severe ghosting in an analog TV broadcast. In television, a ghost is a replica of the transmitted image, offset in position, that is superimposed on top of the main image. It is often caused when a TV signal travels by two different paths to a receiving antenna, with a slight difference in timing. [1]
The ATSC signal is more susceptible to changes in radio propagation conditions than DVB-T and ISDB-T. It also lacks true hierarchical modulation, which would allow the SDTV part of an HDTV signal (or the audio portion of a television program) to be received uninterrupted even in fringe areas where signal strength is low.
QAM is used in a variety of communications systems such as Dial-up modems and WiFi. In cable systems, a QAM tuner is linked to the cable in a manner that is equivalent to an ATSC tuner which is required to receive over-the-air (OTA) digital channels broadcast by local television stations when attached to an antenna. Most new HDTV digital ...