Search results
Results from the WOW.Com Content Network
For a key to function, the shaft and rotating machine element must have a keyway and a keyseat, which is a slot and pocket in which the key fits. The whole system is called a keyed joint . [ 1 ] [ 2 ] A keyed joint may allow relative axial movement between the parts.
A navigational box that can be placed at the bottom of articles. Template parameters [Edit template data] Parameter Description Type Status State state The initial visibility of the navbox Suggested values collapsed expanded autocollapse String suggested Template transclusions Transclusion maintenance Check completeness of transclusions The above documentation is transcluded from Template ...
Slotted spring pin (1) and washer (2) used to secure a shaft (3). A spring pin (also called tension pin or roll pin) is a mechanical fastener that secures the position of two or more parts of a machine relative to each other.
Keyway may refer to: A part of a keyed joint used to connect a rotating machine element to a shaft; see key (engineering) A keyhole , a hole or aperture (as in a door or lock) for receiving a key; see lock and key
These chucks require a toothed key to provide the necessary torque to tighten and loosen the jaws. When the key is turned its teeth mate with teeth on the chuck, turning an internal screw which in turn moves the threaded jaws in or out along a tapered surface. The taper allows the jaws to clamp drill shanks of a range of diameters. The end view ...
For information on using this template, see Template:Routemap. For pictograms used, see Commons:BSicon/Catalogue . Note: Per consensus and convention, most route-map templates are used in a single article in order to separate their complex and fragile syntax from normal article wikitext.
The balance shaft runs off the small gear on the left (the large gear is for the camshaft, causing it to rotate at half the speed of the crankshaft). Balance shafts are often used in inline-four engines , to reduce the second-order vibration (a vertical force oscillating at twice the engine RPM ) that is inherent in the design of a typical ...
In mechanical engineering, a shaft is a rotating machine element, usually circular in cross section, which is used to transmit power from one part to another, or from a machine which produces power to a machine which absorbs power.