Search results
Results from the WOW.Com Content Network
Figure 1: Example two-port network with symbol definitions. Notice the port condition is satisfied: the same current flows into each port as leaves that port.. In electronics, a two-port network (a kind of four-terminal network or quadripole) is an electrical network (i.e. a circuit) or device with two pairs of terminals to connect to external circuits.
Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...
Two terminals where the current into one is identical to the current out of the other. Circuit: A current from one terminal of a generator, through load component(s) and back into the other terminal. A circuit is, in this sense, a one-port network and is a trivial case to analyse.
Y and Δ are important topologies in linear network analysis due to these being the simplest possible three-terminal networks. A Y-Δ transform is available for linear circuits. This transform is important because some networks cannot be analysed in terms of series and parallel combinations.
Wilhelm Cauer found a transformation that could generate all possible equivalents of a given rational, [note 9] passive, linear one-port, [note 8] or in other words, any given two-terminal impedance. Transformations of 4-terminal, especially 2-port, networks are also commonly found and transformations of yet more complex networks are possible.
Linear four-terminal circuits in which a signal is applied to one pair of terminals and an output is taken from another, are often modeled as two-port networks. These can be represented by simple equivalent circuits of impedances and dependent sources.
Simple resistive network with three possible port arrangements: (a) Pole pairs (1, 2) and (3, 4) are ports; (b) pole pairs (1, 4) and (2, 3) are ports; (c) no pair of poles are ports. Any node of a circuit that is available for connection to an external circuit is called a pole (or terminal if it is a physical object).
3.4.2 Triode mode or linear ... the MOSFET is a four-terminal device, and in integrated circuits many of the MOSFETs share a body connection, not necessarily ...