Search results
Results from the WOW.Com Content Network
As transistors grew cheaper, horizontal microcode came to dominate the design of CPUs using microcode, with vertical microcode being used less often. When both vertical and horizontal microcode are used, the horizontal microcode may be referred to as nanocode or picocode .
The first discrete-transistor audio amplifiers barely supplied a few hundred milliwatts, but power and audio fidelity gradually increased as better transistors became available and amplifier architecture evolved. [94] Modern transistor audio amplifiers of up to a few hundred watts are common and relatively inexpensive.
A transistor is used as the active element. The gain of the amplifier is determined by the properties of the transistor itself as well as the circuit it is contained within. [citation needed] Common active devices in transistor amplifiers include bipolar junction transistors (BJTs) and metal oxide semiconductor field-effect transistors (MOSFETs).
For the case when the common-base circuit is used as a voltage amplifier, the circuit is shown in Figure 2. The output resistance is large, at least R C || r O, the value which arises with low source impedance (R S ≪ r E). A large output resistance is undesirable in a voltage amplifier, as it leads to poor voltage division at the output.
Block diagram of a basic class-D amplifier. Note: For clarity, signal periods are not shown to scale. A class-D amplifier, or switching amplifier, is an electronic amplifier in which the amplifying devices (transistors, usually MOSFETs) operate as electronic switches, and not as linear gain devices as in other amplifiers.
The first transistor hi-fi system was developed by engineers at GE and demonstrated at the University of Philadelphia in 1955. [9] In terms of commercial production, The Fisher TR-1 was the first "all transistor" preamplifier, which became available mid-1956. [10] In 1961, a company named Transis-tronics released a solid-state amplifier, the ...
Bootstrapping is a technique in the field of electronics where part of the output of a system is used at startup. A bootstrap circuit is one where part of the output of an amplifier stage is applied to the input, so as to alter the input impedance of the amplifier. When applied deliberately, the intention is usually to increase rather than ...
Generalised FET as an amplifier. A FET amplifier is an amplifier that uses one or more field-effect transistors (FETs). The most common type of FET amplifier is the MOSFET amplifier, which uses metal–oxide–semiconductor FETs (MOSFETs). The main advantage of a FET used for amplification is that it has very high input impedance and low output ...