Search results
Results from the WOW.Com Content Network
Fixed attenuators in circuits are used to lower voltage, dissipate power, and to improve impedance matching. In measuring signals, attenuator pads or adapters are used to lower the amplitude of the signal a known amount to enable measurements, or to protect the measuring device from signal levels that might damage it. Attenuators are also used ...
In an analog television broadcast, the brightness, colors and sound are represented by amplitude, phase and frequency of an analog signal. Analog signals vary over a continuous range of possible values which means that electronic noise and interference may be introduced. Thus with analog, a moderately weak signal becomes snowy and subject to ...
It is possible to also get a bad picture if the signal strength of the TV transmitter is too high. An attenuator inserted in the antenna lead-in wire may be used if the television receiver displays signs of overload in the RF front end. Strong out-of-band signals may also affect television reception and may require band-pass filters to reduce ...
Most cable companies require a set-top box (cable converter box) or a slot on one's TV set for conditional access module cards [2] to view their cable channels, even on newer televisions with digital cable QAM tuners, because most digital cable channels are now encrypted, or scrambled, to reduce cable service theft. A cable from the jack in the ...
In analogue TV broadcasting, the video signal modulates a carrier by a kind of amplitude modulation (VSB modulation or C3F). The modulation polarity is negative. That means that the higher the level of the video signal the lower the power of the RF signal. The lowest possible modulating signal during the synchrone interval yields 100% of the ...
CEA-608-B specifies meaning of the 7-bit field placed on the data lines. The bits 4 and 3 contain the CGMS-A values, the bits 2 and 1 contain the Analog Protection System (APS) value, the bit 0 is the Analog Source Bit (ASB) specifying if the signal originates from a pre-recorded material, bits 5 and 6 are reserved.
A/72 part 2 : AVC Video Transport Subsystem Characteristics [12] The standards support 1080p at 50, 59.94 and 60 frames per second; such frame rates require H.264/AVC High Profile Level 4.2, while standard HDTV frame rates only require Levels 3.2 and 4, and SDTV frame rates require Levels 3 and 3.1. [dubious – discuss]
A television transmitter is a transmitter that is used for terrestrial (over-the-air) television broadcasting.It is an electronic device that radiates radio waves that carry a video signal representing moving images, along with a synchronized audio channel, which is received by television receivers ('televisions' or 'TVs') belonging to a public audience, which display the image on a screen.