Search results
Results from the WOW.Com Content Network
A self-aligning nut, also known as a spherical nut [2] or leveling nut, is a type of nut used in applications where the fastener is not perpendicular to the surface to which the nut anchors. A flange nut is used inside a specially shaped dished-out washer. The device is commonly used in the aerospace industry.
The cage has two wings that when compressed allow the cage to be inserted into the square holes Clip-on nut: J-nut or U-nut, sheet metal nut, speed nut (ambiguously) Designed to be clipped to sheet metal Coupling nut: Extension nut A threaded fastener for joining two male threads, most commonly a threaded rod,[1][2] but also pipes Flange nut ...
The thicker nut applies more force to the joint, first relieving the force on the threads of the thinner nut and then applying a force in the opposite direction. In this way the thicker nut presses tightly on the side of the threads away from the joint, while the thinner nut presses on the side of the threads nearest the joint, tightly locking ...
The Pitch Circle Diameter (PCD) is the diameter of that circle that passes through the center of all the bolt holes or wheel bolts or wheel rim holes or studs. The best example is Flanges, there are multiple holes in the Flanges, the circle through the center of these holes is known as the pitch circle, and the diameter of this circle is known ...
It indicates the diameter of smooth-walled hole that a male thread (e.g. on a bolt) will pass through easily to connect to an internally threaded component (e.g. a nut) on the other side. For example, an M6 screw has a nominal outer diameter of 6 millimetres and will therefore be a well-located, co-axial fit in a hole drilled to 6 mm diameter.
A coupling nut A coupling nut and its orthographic view. A coupling nut, also known as extension nut, is a threaded fastener for joining two male threads, most commonly a threaded rod, [1] [2] but also pipes. [3] The outside of the fastener is usually hexagonal so a wrench can hold it.
The tapped hole (or nut) into which the screw fits, has an internal diameter which is the size of the screw minus the pitch of the thread. Thus, an M6 screw, which has a pitch of 1 mm, is made by threading a 6 mm shank, and the nut or threaded hole is made by tapping threads into a hole of 5 mm diameter (6 mm − 1 mm).
Some bolt heads instead lock the bolt in place, so that it does not move and a tool is only needed for the nut end. Common bolt heads include hex, slotted hex washer, and socket cap. The first bolts had square heads, formed by forging. These are still found, although much more common today is the hexagonal head.