enow.com Web Search

  1. Ads

    related to: mechanical nut splitter

Search results

  1. Results from the WOW.Com Content Network
  2. Screw extractor - Wikipedia

    en.wikipedia.org/wiki/Screw_extractor

    The screw is drilled out with the appropriate drill and drill bushing. The extractor is then hammered into the hole with a brass hammer, because a steel hammer is more likely to cause the extractor to break. The appropriate special nut is then attached to the end of the extractor. The nuts can then be turned with a wrench to remove the screw. [1]

  3. Split nut - Wikipedia

    en.wikipedia.org/wiki/Split_nut

    A split nut is a nut that is split lengthwise into two pieces (opposed halves) so that its female thread may be opened and closed over the male thread of a bolt or leadscrew. [1] This allows the nut, when open, to move along the screw without the screw turning (or, vice versa, to allow the screw to pass through the nut without turning).

  4. Nut (hardware) - Wikipedia

    en.wikipedia.org/wiki/Nut_(hardware)

    A nut is a type of fastener with a threaded hole. Nuts are almost always used in conjunction with a mating bolt to fasten multiple parts together. The two partners are kept together by a combination of their threads' friction (with slight elastic deformation ), a slight stretching of the bolt, and compression of the parts to be held together.

  5. Screw mechanism - Wikipedia

    en.wikipedia.org/wiki/Screw_mechanism

    The lead determines the mechanical advantage of the screw; the smaller the lead, the higher the mechanical advantage. [20] The pitch is defined as the axial distance between the crests of adjacent threads. In most screws, called "single start" screws, which have a single helical thread wrapped around them, the lead and pitch are equal.

  6. Leadscrew - Wikipedia

    en.wikipedia.org/wiki/Leadscrew

    A split nut can also be used to compensate for wear by compressing the parts of the nut. A hydrostatic leadscrew overcomes many of the disadvantages of a normal leadscrew, having high positional accuracy, very low friction, and very low wear, but requires continuous supply of high-pressure fluid and high-precision manufacture, leading to ...

  7. Tap and die - Wikipedia

    en.wikipedia.org/wiki/Tap_and_die

    A tap is used to cut or form the female portion of the mating pair (e.g. a nut). A die is used to cut or form the male portion of the mating pair (e.g. a bolt). The process of cutting or forming threads using a tap is called tapping, whereas the process using a die is called threading.

  1. Ads

    related to: mechanical nut splitter