Ad
related to: how to connect rj11 connector to usb
Search results
Results from the WOW.Com Content Network
Cords connecting to an RJ11 interface require a 6P2C connector. Nevertheless, cords sold as RJ11 often use 6P4C connectors (six position, four conductor) with four wires. Two of the six possible contact positions connect tip and ring, and the other two conductors are unused. RJ11 is commonly used to connect DSL modems to the customer line.
For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...
The connector is also used in other telecommunications connections, including ISDN and T1. Where building network and telephone wiring is pre-installed, the center (blue) pair is often used to carry telephony signals. While this allows an RJ11 plug to connect, it may damage the modular jack; an approved converter prevents damage.
The USB Type-C Cable and Connector Specification specifies a mapping from a USB-C jack to a 4-pole TRRS jack, for the use of headsets, and supports both CTIA and OMTP (YD/T 1885–2009) modes. [79] Some devices transparently handle many jack standards, [80] [81] and there are hardware implementations of this available as components. [82]
One USB 2.0 connector Smart Hub 1 and 2 ... 1.5 and 2.0 devices connect to the Internet using a standard ADSL ... Broadband cable (RJ11 to RJ11) Ethernet cable (RJ45 ...
An Internet-accessing smartphone may have the same capabilities as a standalone modem, and, when connected via a USB cable to a computer, can serve as a modem for the computer. Smartphones with built-in Wi-Fi also typically provide routing and wireless access point facilities. This method of connecting is commonly referred to as "tethering." [9]
Some keystones use a pass-through type connector, where there is a jack on both the front face and the rear side. Others only have a jack on the front and employ a different mechanism for hard-wiring signal cables to the rear, such as a mini 110 block , an insulation-displacement connector , or a crimp or solder connection.
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
Ad
related to: how to connect rj11 connector to usb