Search results
Results from the WOW.Com Content Network
FPS units. 7.853 982 × 10−7 in2. A circular mil is a unit of area, equal to the area of a circle with a diameter of one mil (one thousandth of an inch or 0.0254 mm). It is equal to π /4 square mils or approximately 5.067 × 10−4 mm2. It is a unit intended for referring to the area of a wire with a circular cross section.
In the metric system, the mass per unit area of all types of textiles is expressed in grams per square metre (g/m 2). The gram (alternative spelling: gramme; SI unit symbol: g) is a metric system unit of mass. A gram is defined as one thousandth of the SI base unit, the kilogram, or 1 × 10−3 kg.
1 / 1296 sq yd. A square inch (plural: square inches) is a unit of area, equal to the area of a square with sides of one inch. The following symbols are used to denote square inches: The square inch is a common unit of measurement in the United States and the United Kingdom. A common unit of pressure, pound per square inch (psi) is derived ...
No. 7/0, the largest size, is 0.50 inches (500 mils or 12.7 mm) in diameter (250 000 circular mils in cross-sectional area), and the smallest, No. 50, is 0.001 inches (1 mil or 25.4 μm) in diameter (1 circular mil [cross-sectional area] or 0.7854 millionths of a square inch). Between each step the diameter, or thickness, diminishes by 10.557% ...
10−6 in2. SI units. 6.45160 × 10 −4 mm 2. A square mil is a unit of area, equal to the area of a square with sides of length one mil. A mil is one thousandth of an international inch. This unit of area is usually used in specifying the area of the cross section of a wire or cable.
Metric drill bit sizes. Metric drill set, 1.0–6.0 mm by 0.1 mm, jobber length. The case that holds them in an indexed order (by size), via a graduated series of holes, is called a drill index. Metric drill bit sizes define the diameter of the bit in terms of standard metric lengths. Standards organizations define sets of sizes that are ...
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0 ...
A table of the gauge numbers and wire diameters is shown below. [1] [2] The basis of the system is the thou (or mil in US English), or 0.001 in. Sizes are specified as wire diameters, stated in thou and tenths of a thou (mils and tenths). The wire diameter diminishes with increasing size number.