Search results
Results from the WOW.Com Content Network
The illustration is the interior of a common two wire heat-only household thermostat, used to regulate a gas-fired heater via an electric gas valve. Similar mechanisms may also be used to control oil furnaces, boilers, boiler zone valves , electric attic fans, electric furnaces, electric baseboard heaters, and household appliances such as ...
A thermal expansion valve is a key element to a heat pump; this is the cycle that makes air conditioning, or air cooling, possible.A basic refrigeration cycle consists of four major elements: a compressor, a condenser, a metering device and an evaporator.
Solenoid valves. A solenoid valve is an electromechanically operated valve.. Solenoid valves differ in the characteristics of the electric current they use, the strength of the magnetic field they generate, the mechanism they use to regulate the fluid, and the type and characteristics of fluid they control.
The starter motor is a series, compound, or permanent magnet type electric motor with a solenoid and solenoid operated switch mounted on it. When low-current power from the starting battery is applied to the starter solenoid, usually through a key-operated switch, the solenoid closes high-current contacts for the starter motor and it starts to ...
This is due to the fact that the fuel hits the intake valves on the way to the combustion chamber, allowing the detergents in the fuel to keep them clean. However, carbon build-up on intake valves is a problem for engines with direct injection only, as the fuel is injected directly into the combustion chamber.
A variable force solenoid (VFS) is an electro-hydraulic device that controls pressure proportionally or inversely proportionally to a signal (voltage or current) obtained from the on-board controller of a powertrain. A low flow VFS is used as a signal level devices for transmission line pressure control or application of clutches.
[clarification needed] Most electrical tankless heaters require AWG 10 or 8 wire, corresponding to 5.5 or 8.5 mm 2 for typical POU (point of use) heaters at North American voltages. Larger whole-house electric units may require up to AWG 2 wire. In gas appliances, both pressure and volume requirements must be met for optimum operation.
Gasoline direct injection (GDI), also known as petrol direct injection (PDI), [1] is a mixture formation system for internal combustion engines that run on gasoline (petrol), where fuel is injected into the combustion chamber.