Search results
Results from the WOW.Com Content Network
The Pelton wheel or Pelton Turbine is an impulse-type water turbine invented by American inventor Lester Allan Pelton in the 1870s. [ 1 ] [ 2 ] The Pelton wheel extracts energy from the impulse of moving water, as opposed to water's dead weight like the traditional overshot water wheel .
Pelton patented his wheel as well as his novel design of the double cup runner, and in 1888 formed the Pelton Water Wheel Company in San Francisco to supply the growing demand for hydropower and hydroelectricity throughout the West and world-wide. [6] 'Pelton' is a trademark name for the products of that company, but the term is widely used ...
Campbell Diagram of a steam turbine. Analysis shows that there are well-damped critical speed at lower speed range. Analysis shows that there are well-damped critical speed at lower speed range. Another critical speed at mode 4 is observed at 7810 rpm (130 Hz) in dangerous vicinity of nominal shaft speed, but it has 30% damping - enough to ...
This is the modern form of the Pelton turbine which today achieves up to 92% efficiency. Pelton had been quite an effective promoter of his design and although Doble took over the Pelton company he did not change the name to Doble because it had brand name recognition. Turgo and cross-flow turbines were later impulse designs.
With the help of these equations the head developed by a pump and the head utilised by a turbine can be easily determined. As the name suggests these equations were formulated by Leonhard Euler in the eighteenth century. [1] These equations can be derived from the moment of momentum equation when applied for a pump or a turbine.
The turbine assembly is a five-jet configuration; the stream of each jet is 184.7 mm (7.2716535 inches) in diameter with an exit velocity of 191.5 meters/second (628.28 ft/s). The kinetic energy of each of the 5 streams i.e. 1 from each jet) is approximately 92.16 MW (Q = 5 cubic meters per second, v = 191.5 m/s, H = 1869 m).
The Turgo turbine is an impulse type turbine; water does not change pressure as it moves through the turbine blades. The water's potential energy is converted to kinetic energy with a nozzle. The high speed water jet is then directed on the turbine blades which deflect and reverse the flow.
Lake Mutt in 2006. The highest reservoir in the complex is Lake Mutt (Muttsee), situated at 2,474 m (8,117 ft) above sea level.It had an original storage capacity of 9,000,000 m 3 (7,300 acre⋅ft), and was later expanded to 25,000,000 m 3 (20,000 acre⋅ft) during the Linthal 2015 expansion, to hold extra capacity for the new pumped-storage power station.