Search results
Results from the WOW.Com Content Network
Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [24] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.
Track (measured between center line of wheels) In automobiles (and other wheeled vehicles which have two wheels on an axle), the axle track is the distance between the hub flanges on an axle. [1] Wheel track, track width or simply track refers to the distance between the centerline of two wheels on the same axle. In the case of an axle with ...
Studded mountain bike tires for icy conditions. Off-road tires used in mud or dirt feature individual knob patterns to allow the tire to bite into the surface and lever the sides of the tread to get a better grip. Given the smaller contact patch, these tires tend to wear quickly when used on asphalt (depending on type of rubber).
It can be fitted to a conventional car or truck to turn it into a half-track, suitable for use over rough or soft ground. Conventional front wheels and steering are used, although skis may also be fitted. A snowmobile is a smaller ski-only type. "Russo-Balt" "C24-30" from the garage of Tsar Nicholas II with Kégresse track. Adolphe Kégresse ...
A cross-section of a tire. Number 12 indicates the radial ply. Numbers 14 and 16 are bias plies. A radial tire (more properly, a radial-ply tire) is a particular design of vehicular tire. In this design, the cord plies are arranged at 90 degrees to the direction of travel, or radially (from the center of the tire).
Uniform Tire Quality Grading, commonly abbreviated as UTQG, is a set of standards for passenger car tires that measures a tire's treadwear, temperature resistance and traction. The UTQG was created by the National Highway Traffic Safety Administration in 1978, a branch of the United States Department of Transportation (DOT). [ 1 ]
Tire bead is the term for the edge of a tire that sits on the rim. Wheels for automobiles, bicycles, etc. are made with a small slot or groove into which the tire bead sits. When the tire is properly inflated, the air pressure within the tire keeps the bead in this groove. Reducing tire air pressure is a frequent practice among off-road vehicle ...
Vehicles typically carry a spare tire, already mounted on a wheel rim, to be used in the event of a flat tire or blowout.Spare tires (sometimes called "doughnuts") for modern cars are smaller than regular tires (to save trunk space, weight and cost) and should not be used to drive very far before replacement with a full-size tire.