Search results
Results from the WOW.Com Content Network
A safety wire is used to ensure proper security for a fastener. The wire needed is long enough to reach from a fixed location to a hole in the removable fastener, such as a pin — a clevis fastener, sometimes a linchpin or hitch-pin through a clevis yoke for instance — and the wire pulled back upon itself, parallel to its other end, then twisted, a single end inserted through a fastener ...
An output signal switching device (OSSD) is an electronic device used as part of the safety system of a machine. It provides a coded signal which, when interrupted due to a safety event, signals the machine to shut down. It works by converting the standard direct current supply, usually 24 volts, into two pulsed and out-of-phase signals.
These practices are not a means of obtaining or maintaining torque, rather a safety device to prevent the disengagement of screws, nuts, bolts, snap rings, oil caps, drain cocks, valves, and parts. Three basic methods are used in safetying; safety-wire, cotter pins, and self-locking nuts. Retainer washers and pal nuts are also sometimes used. [2]
Hazardous chemicals present physical and/or health threats to workers in clinical, industrial, and academic laboratories. Laboratory chemicals include cancer-causing agents (carcinogens), toxins (e.g., those affecting the liver, kidney, and nervous system), irritants, corrosives, sensitizers, as well as agents that act on the blood system or damage the lungs, skin, eyes, or mucous membranes.
Intrinsic safety (IS) is a protection technique for safe operation of electrical equipment in hazardous areas by limiting the energy, electrical and thermal, available for ignition. In signal and control circuits that can operate with low currents and voltages, the intrinsic safety approach simplifies circuits and reduces installation cost over ...
In functional safety a safety instrumented system (SIS) is an engineered set of hardware and software controls which provides a protection layer that shuts down a chemical, nuclear, electrical, or mechanical system, or part of it, if a hazardous condition is detected.
In electronics and electrical engineering, a fuse is an electrical safety device that operates to provide overcurrent protection of an electrical circuit. Its essential component is a metal wire or strip that melts when too much current flows through it, thereby stopping or interrupting the current.
Wire gauze or wire mesh is a gauze woven of metal wire, or very fine, gauze-like wire netting. Wire gauze is placed on the support ring that is attached to the retort stand between a burner and glassware , or is placed on a tripod to support beakers , flasks , or other glassware to protect it during heating.