Search results
Results from the WOW.Com Content Network
A similar system, termed British Engineering Units by Halliday and Resnick (1974), is a system that uses the slug as the unit of mass, and in which Newton's law retains the form F = ma. [5] Modern British engineering practice has used SI base units since at least the late 1970s.
In unit systems where force is a derived unit, like in SI units, g c is equal to 1. In unit systems where force is a primary unit, like in imperial and US customary measurement systems, g c may or may not equal 1 depending on the units used, and value other than 1 may be required to obtain correct results. [2]
The carat was once specified as four grains in the English-speaking world. Some local units in the English dominion were (re-)defined in simple terms of English units, such as the Indian tola of 180 grains. Tod This was an English weight for wool. [32] It has the alternative spelling forms of tode, todd, todde, toad, and tood. [33]
The technical or gravitational FPS system [6] or British gravitational system is a coherent variant of the FPS system that is most common among engineers in the United States. It takes the pound-force as a fundamental unit of force instead of the pound as a fundamental unit of mass. In this sub-system, the unit of mass is a derived unit known ...
The units of cubic length (the cubic inch, cubic foot, cubic mile, etc.) are the same in the imperial and US customary systems, but they differ in their specific units of volume (the bushel, gallon, fluid ounce, etc.). The US customary system has one set of units for fluids and another set for dry goods.
The CGS system has been largely supplanted by the MKS system based on the metre, kilogram, and second, which was in turn extended and replaced by the International System of Units (SI). In many fields of science and engineering, SI is the only system of units in use, but CGS is still prevalent in certain subfields.
Centimetre–gram–second system of units; CGS system of units; Chinese units of measurement; Coherence (units of measurement) Comparison of the imperial and US customary measurement systems; Composition of Yards and Perches; Conventional electrical unit
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.