Search results
Results from the WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
A throttle body is somewhat analogous to the carburetor in a non-injected engine, although it is important to remember that a throttle body is not the same thing as a throttle, and that carbureted engines have throttles as well. A throttle body simply supplies a convenient place to mount a throttle in the absence of a carburetor venturi.
There is essentially no difference in efficiency between the technique of bypassing the throttle butterfly and operating the butterfly itself. The IAC allows the ECU to maintain minimum RPM irrespective of changes in engine load, sometimes referred to as anti-stall feature. Thus the driver can more easily move the car from stand-still by merely ...
An accelerator pump is either remotely mounted or mounted on the carburetor body. The accelerator pump is either mechanically connected to the throttle, or it is operated by sensing the manifold pressure change when the throttle is opened. Either way, it injects a measured amount of extra fuel into the air stream to allow smooth engine ...
As the throttle is closed, this pressure is reduced due to restricting the fuel/air mixture available to the engine, i.e. causing it to operate at lower power than it is capable of producing. Oil temperature gauge - Indicates the engine oil temperature. Oil pressure gauge - Indicates the supply pressure of the engine lubricant.
There exist two types of manifold injection systems: multi-point (or port) and single-point (or throttle body) injection. Internal mixture formation systems can be separated into several different varieties of direct and indirect injection, the most common being the common-rail injection, a variety of direct injection.
Manifold vacuum, or engine vacuum in a petrol engine is the difference in air pressure between the engine's intake manifold and Earth's atmosphere.. Manifold vacuum is an effect of a piston's movement on the induction stroke and the airflow through a throttle in the intervening carburetor or throttle body leading to the intake manifold.