Search results
Results from the WOW.Com Content Network
In the latter case, inline appliances are preferred. These would generally 'sit' between the LAN and the LAN's exit point, generally the WAN or Internet router, and all packets leaving and entering the network would go through them. In most cases the appliance would operate as a bridge on the network so that it is undetectable by users.
Gateway Load Balancing Protocol (GLBP) is a Cisco proprietary protocol that attempts to overcome the limitations of existing redundant router protocols by adding basic load balancing functionality. In addition to being able to set priorities on different gateway routers, GLBP allows a weighting parameter to be set.
Network load balancing is the ability to balance traffic across two or more WAN links without using complex routing protocols like BGP.. This capability balances network sessions like Web, email, etc. over multiple connections in order to spread out the amount of bandwidth used by each LAN user, thus increasing the total amount of bandwidth available.
Diagram illustrating user requests to an Elasticsearch cluster being distributed by a load balancer. (Example for Wikipedia.) In computing, load balancing is the process of distributing a set of tasks over a set of resources (computing units), with the aim of making their overall processing more efficient. Load balancing can optimize response ...
When talking about circuit bit rates, people will interchangeably use the terms throughput, bandwidth and speed, and refer to a circuit as being a '64 k' circuit, or a '2 meg' circuit — meaning 64 kbit/s or 2 Mbit/s (see also the List of connection bandwidths). However, a '64 k' circuit will not transmit a '64 k' file in one second.
The route will go in the direction of the gateway with the lowest metric. A router metric is typically based on information such as path length, bandwidth, load, hop count, path cost, delay, maximum transmission unit (MTU), reliability and communications cost.
The speed of light imposes a minimum propagation time on all electromagnetic signals. It is not possible to reduce the latency below = / where s is the distance and c m is the speed of light in the medium (roughly 200,000 km/s for most fiber or electrical media, depending on their velocity factor).
In addition, there is a basic layer-3 aggregation [22] that allows servers with multiple IP interfaces on the same network to perform load balancing, and for home users with more than one internet connection, to increase connection speed by sharing the load on all interfaces. [23]