Search results
Results from the WOW.Com Content Network
The iron pipe size standard came into being early in the 19th century and remained in effect until after World War II. The IPS system was primarily used in the United States and the United Kingdom. In the 1920s, the Copper Tube Size (CTS) standard was combined with the IPS standard.
The most common materials for corrugated iron are ferrous alloys (e.g. stainless steels), aluminium and copper. Regular ferrous alloys are the most common due to price and availability. Common sizes of corrugated material can range from a very thin 30 gauge (0.012 inches, 0.3 mm) to a relatively thick 6 gauge (0.1943 inches, 5 mm). Thicker or ...
The British, European and International standard for hot-dip galvanizing is BS EN ISO 1461, which specifies a minimum coating thickness to be applied to steel in relation to the steels section thickness e.g. a steel fabrication with a section size thicker than 6 mm shall have a minimum galvanized coating thickness of 85 μm.
In plumbing, the term "45-degree elbow" for example, refers to the angle of bend from the original straight pipe position (0 degrees) to the new position (45 degrees), not the actual angle formed by the joint. On a protractor, the actual angle of the above joint is 135 degrees, an obtuse angle.
It is also weldable and can be used in structural applications, although ASTM A500 tube, which is available in the same NPS sizes, is sometime preferred. [ 2 ] This is a standard set by the standards organization ASTM International , a voluntary standards development organizations that sets technical standards for materials, products, systems ...
The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread. The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′.
A conversion coating is a chemical or electro-chemical treatment applied to manufactured parts that superficially converts the material into a thin adhering coating of an insoluble compound. These coatings are commonly applied to protect the part against corrosion , to improve the adherence of other coatings, for lubrication , or for aesthetic ...
This page was last edited on 30 June 2012, at 11:33 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may ...