Search results
Results from the WOW.Com Content Network
Using aseptic technique, prepare and air dried heat fixed slide with the desired organism. Prepare a boiling water bath. Cover the slide with a piece of paper towel and place on staining rack over the water bath. Flood the paper towel on the slide with Malachite Green (primary stain). Steam the slide for 5 to 7 minutes (mordant).
Once stained, they do not decolourize. The addition of heat during the staining process is a huge contributing factor. [15] Heat helps open the spore's membrane so the dye can enter. The main purpose of this stain is to show germination of bacterial spores.
Applying a primary stain (crystal violet) to a heat-fixed smear of a bacterial culture. Heat fixation kills some bacteria but is mostly used to affix the bacteria to the slide so that they do not rinse out during the staining procedure. The addition of iodine, which binds to crystal violet and traps it in the cell
Catchment zone in Nattai, Australia containing drinking water. Catchment hydrology is the study of hydrology in drainage basins. Catchments are areas of land where runoff collects to a specific zone. This movement is caused by water moving from areas of high energy to low energy due to the influence of gravity.
Pinch analysis is a methodology for minimising energy consumption of chemical processes by calculating thermodynamically feasible energy targets (or minimum energy consumption) and achieving them by optimising heat recovery systems, energy supply methods and process operating conditions.
Food moisture analysis is the determination of the concentration of water in a food sample. A variety of techniques may be used including Karl Fischer titration and loss on drying. Many technical standards exist which define test methods for determining moisture in different types of food.
The Drinking Water Inspectorate is a section of Department for Environment, Food and Rural Affairs set up to regulate the public water supply companies in England and Wales. [6] Water testing in England and Wales can be conducted at the environmental health office at the local authority. [7] See Drinking Water Inspectorate.
The source and sink composite curves is a graphical tool for setting water recovery targets as well as for design of water recovery networks. [5] A 2018 study found by water pinch and water footprint analysis that for bricks with typical materials of clay and shale, the water consumption footprint was 2.02 L of water per brick. [6]