Search results
Results from the WOW.Com Content Network
This process took a total of 0.02 seconds of CPU time (User + System). The reported System time is 0.00 seconds, indicating that the amount of System time used was less than the printed resolution of 0.01 seconds. Elapsed real time was 0.08 seconds. The following is the source code of the application nextPrimeNumber which was used in the above ...
To get better CPI values with pipelining, there must be at least two execution units. For example, with two executions units, two new instructions are fetched every clock cycle by exploiting instruction-level parallelism, therefore two different instructions would complete stage 5 in every clock cycle and on average the number of clock cycles ...
The number of instructions per second and floating point operations per second for a processor can be derived by multiplying the number of instructions per cycle with the clock rate (cycles per second given in Hertz) of the processor in question. The number of instructions per second is an approximate indicator of the likely performance of the ...
Instructions per second (IPS) is a measure of a computer's processor speed. For complex instruction set computers (CISCs), different instructions take different amounts of time, so the value measured depends on the instruction mix; even for comparing processors in the same family the IPS measurement can be problematic.
computes the difference in seconds between two time_t values time: returns the current time of the system as a time_t value, number of seconds, (which is usually time since an epoch, typically the Unix epoch). The value of the epoch is operating system dependent; 1900 and 1970 are often used. See RFC 868. clock
10 −3: millisecond: ms One thousandth of one second 1 ms: The time for a neuron in the human brain to fire one impulse and return to rest [13] 4–8 ms: The typical seek time for a computer hard disk: 10 −2: centisecond cs One hundredth of one second 1.6667 cs: The period of a frame at a frame rate of 60 Hz.
If we ignore both these effects, then the average memory access time becomes an important metric. It provides a measure of the performance of the memory systems and hierarchies. It refers to the average time it takes to perform a memory access. It is the addition of the execution time for the memory instructions and the memory stall cycles.
10 nanoseconds, also a casual term for a short period of time. microsecond: 10 −6 s: One millionth of a second. Symbol is μs millisecond: 10 −3 s: One thousandth of a second. Shortest time unit used on stopwatches. jiffy (electronics) ~ 10 −3 s: Used to measure the time between alternating power cycles. Also a casual term for a short ...