Search results
Results from the WOW.Com Content Network
A flow control structure is a device that alters the flow of water in a stream, drainage channel or pipe. As a group these are passive structures since they operate without intervention under different amounts of water flow and their impact changes based on the quantity of water available.
English: In a typical leaded bell-and-spigot joint, the spigot is inserted into the bell of another pipe, yarn or oakum is compressed into the space, then hot lead was poured and also worked into the joint. Installers would typically use a set of tools, with different sized heads, to make sure both the yarn and lead were properly worked into ...
A low-flow fixture is a water saving plumbing fixture designed to achieve water savings by having a lower flow rate of water or a smaller quantity per flush. Some of these low-flow fixtures are faucets , showerheads, and toilets .
Flow splitters are used to reduce the likelihood of nappe vibration that might cause the failure of a dam wall by aerating the water flow. They are also used to restrict large flows of stormwater , in situations where a stormwater management device is designed only to treat small storms.
Faucet is the most common term in the US, similar in use to "tap" in British English, e.g. "water faucet" (although the term "tap" is also used in the US). Spigot is used by professionals in the trade (such as plumbers), and typically refers to an outdoor fixture.
English: Diagram of a water distribution system. Inlet water goes through a pumping station. The water is delivered to the top of a water tank. Water pressure created by gravity and delivered to water mains. Water mains are connected to fire hydrants and service lines which are pipes that connect a water main to a building.
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
Concentrated solar power can achieve the high temperatures necessary to split water. Hydrosol-2 is a 100-kilowatt pilot plant at the Plataforma Solar de Almería in Spain which uses sunlight to obtain the required 800 to 1,200 °C (1,070 to 1,470 K; 1,470 to 2,190 °F) to split water. Hydrosol II has been in operation since 2008.